Designations and indicators of car control buttons shall comply with Section 11B-411.4.7....
Search Results "Seat Designation"
-
11B-411.4.7 Designations and indicators of car control buttons
-
11B-411.4.7 Designations and indicators of car control buttons
Designations and indicators of car control buttons shall comply with Section 11B-411.4.7....
- Designing Activities in Proloquo2Go 4
-
Attachment I: Program Access in Existing Facilities
Attachment I: Program Access in Existing Facilities
-
5.4.6 Transfer Support Gripping Surface Cross Section and Clearances for M301, M302, and M305.2
appropriate for the gripping surfaces of transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
F221.2.1.1 General Seating
[ECTCR UFAS 4.1.2(18)(a) depending on assembly size] Table F221.2.1.1 Number of Wheelchair Spaces in Assembly Areas Number of Seats Minimum Number of Required Wheelchair...
-
11B-1002.4.7.1 Shoulder-to-shoulder seating
Where an amusement ride provides shoulder-to-shoulder seating, companion seats shall be shoulder-to-shoulder with the adjacent wheelchair space....
-
11B-1002.4.7.1 Shoulder-to-shoulder seating
Where an amusement ride provides shoulder-to-shoulder seating, companion seats shall be shoulder-to-shoulder with the adjacent wheelchair space....
-
EXPLANATION OF STUDY DESIGN
EXPLANATION OF STUDY DESIGN...
-
Bathroom Design Illustrations
Other commenters stated that the Department's bathroom design illustrations at 55 FR 24374-24375 are not consistent with the Figure 8 bathroom design illustrations at 55 FR 24401....
-
T402.2 Design Load
Ramps and bridgeplates 30 inches (760 mm) or more in length shall be designed to support a load of 600 pounds (273 kg) minimum, placed at the centroid of the ramp distributed over an area...
- Kohler C3® 125 Elongated Bidet Toilet Seat With Side Controls and Tank Heater Video
-
T603.3 Design Load
Wheelchair securement systems shall comply with the design loads specified in T603.3.1 or T603.3.2, as applicable....
-
SETTLEMENT AGREEMENT BETWEEN AND AMONG THE UNITED STATES OF AMERICA, [redacted], THE CITY OF HARTFORD, et al., UNDER THE ADA
SETTLEMENT AGREEMENT BETWEEN AND AMONG THE UNITED STATES OF AMERICA, [redacted], THE CITY OF HARTFORD, CONNECTICUT INNOVATIONS, INC., AEG MANAGEMENT CT LLC, NORTHLAND TRUMBULL BLOCK...
-
ADA Standards for Accessible Design Pocket Guide: ADA Standard Section 2010
The complete guide to the 2010 ADA Standards for Accessible Design with notes provided by national accessibility experts Evan Terry Associates
-
Salsbury Industries Designer Wood Locker
Requires the Registered User plan or above. Login!
- Accessible Shared Streets: Notable Practices and Considerations for Accommodating Pedestrians with Vision Disabilities
-
DSA IR 11B-9: Accessibility Requirements for Solar Photovoltaic Systems at School Sites
Part 2: California Building Code, Chapter 11B This Interpretation of Regulations (IR) is intended for use by the Division of the State Architect (DSA) staff, and as a resource for design...
-
§ 36.302(f)(3) Identification of accessible seating
(3) Identification of accessible seating. ...
-
11B-216.2 Designations
[2010 ADAS] Advisory 216.2 Designations. ...
-
M305.2.3 Height (Section-by-Section Analysis)
determined that this recommendation did not conflict with the IEC 60601-2-52, which provides requirements for side rails to prevent entrapment hazards, and would allow the equipment to be designed...
- California Commission on Disability Access (CCDA)
- CCDA (California Commission on Disability Access) Accessibility Construction Inspection Checklist
-
5.1 Transfer Surface Height Recommendations
The height provision is the same for MDE used by patients in supine, prone, or side-lying positions (M301) and patients in seated positions (M302)....