APPENDIX E SEATING PLANS FOR MODIFIED THEATERS...
Search Results "Water Closet Seat"
Filters
Commonly Searched Documents
-
APPENDIX E - SEATING PLANS FOR MODIFIED THEATERS
-
Hot water heaters and knee clearance
If the hot water has sharp or abrasive edges or if the piping serving the hot water heater falls within the required knee clearance.............
-
Types of Alternative Designs
Respondents reported the following types of design alternatives: Water Closet: The water closet was moved further away from the sidewall (> 18+" from the sidewall to the centerline...
-
Team or player seating areas. (Section-by-Section Analysis)
Section 221.2.1.4 of the 2004 ADAAG requires one or more wheelchair spaces to be provided in each team or player seating area with fixed seats, depending upon the number of seats provided...
-
San Jamar C3165FBL Medium Pull-Type Water Cup Dispenser
Our Medium Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
San Jamar C3165WH Medium Pull-Type Water Cup Dispenser
Our Medium Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
San Jamar C3165TBL Medium Pull-Type Water Cup Dispenser
Our Medium Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
Error/Omission: Toilet rooms with 6 or more toilet stalls lack a 36" wide "ambulatory" toilet stall.
Requirement: 4.22.4, 4.23.4 Water Closets....
-
Section 36.308 Seating in Assembly Areas (Section-by-Section Analysis)
Section 36.308(a)(1)(ii)(A) and (B) have been revised to provide that wheelchair and companion seats must be an integral part of the seating area, dispersed to all accessible seating levels...
-
M305.2.1 Location (Section-by-Section Analysis)
patients in the supine, prone, or side-lying position with end transfer surfaces, M301.2.3.1 in the final rule, and all diagnostic equipment with transfer surfaces used by patients in the seated...
-
San Jamar C4150SS Small Pull-Type Water Cup Dispenser
Our Small Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
San Jamar C4160WH Small Pull-Type Water Cup Dispenser
Our Small Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
San Jamar C4160TBL Small Pull-Type Water Cup Dispenser
Our Small Pull–Type Water Cup Dispensers are designed with smart features and available in attractive colors and finishes to fit any application....
-
M305.2.1 Location
Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the...
-
M305.2.4 Cross Section
Transfer supports shall have a cross section complying with 305.2.4.1 or 305.2.4.2.
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed...
-
M305.2.6 Gripping Surface
Transfer support gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides. The bottoms of transfer support gripping surfaces...
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports. However, in the MDE NPRM preamble the Access Board repeatedly noted that...
-
M305.2.3 Height (Section-by-Section Analysis)
In the MDE NPRM there was no specific requirement regarding the height of the transfer support, only that it be “within reach” of the patient (proposed M305.2.1). The Access Board...
-
M305.2.4 Cross Section (Section-by-Section Analysis)
The proposed rule did not provide specific requirements for the cross section of transfer supports. However, in the MDE NPRM preamble, the Access Board noted that it was considering...
-
5.4.9 Interruptions along Transfer Support Gripping Recommendation for M301 and M302
5.4.9 Interruptions along Transfer Support Gripping Recommendation for M301 and M302 Description: Transfer supports may contain elements to provide structural support or prevent...
-
5.4.5 Transfer Support Position Recommendation for M301 and M302
5.4.5 Transfer Support Position Recommendation for M301 and M302 Description: Transfer support position refers to the placement of the gripping surface within the minimum and...
-
5.4.2 Transfer Support Length for M301 and M302
5.4.2 Transfer Support Length for M301 and M302 Description: Transfer support length applies to the gripping surface of the support, that portion of the support used to grasp or...
-
5.3 Transfer Sides
5.3 Transfer Sides.
