Relative heights were calculated for high and low transfers for all three protocols. Refer to Addendum A for the definition of relative height. The following tables F1-F3 represent...
Search Results "Ground Surface"
Commonly Searched Documents
-
Addendum F: Relative Height Differences
-
1133A.4.1, Item 3
3. The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent...
-
1.1.12 Ramp cross slope
1.1.12 Ramp cross slope. Measure for overall cross slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the...
-
1133A.4.1, Item 3
3. The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent...
-
1012.5 Slope
This section requires the slope of the surface of parking spaces and pull-up spaces to not be steeper than 1:48 in any direction....
-
Passenger Loading Zones [4.6.6]
A level surface (maximum 2% slope in any direction) for both the space and aisle is important for wheelchair transfer to and from vehicles and deployment of vehicle lifts or ramps....
- Smith System Flex Single-Student Desk with Hard Plastic Top - 01369
- Mockett TLEL3 Electrically Driven Adjustable Table Legs
- Teknion Journal Extended Range Height-Adjustable Table
- Smith System Planner Access Station 24″ Deep Table
- Populas Infinity Workstation
- Smith System Flex Single-Student Desk 01368 & 01371
- Nystrom Building Products MatDesign Roll-Up Mats
- Mats Inc. Grate Mat
- Populas Accella Adjustable Activity / Computer Workstation
- Diversified Woodcrafts ADA Compatible Mobile Lab Station with Flat Top 4352KF-RS
- Smith System Husky Round Activity Table
- Mockett TLKNB27 Original Kyros Leg 5" Base
- Kompan, Inc. M7000 - Red House Playhouse
-
§ 35.151(f)(1)
sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with section 809.2.2 of the 2010 Standards and kitchen work surfaces...
-
11B-805.7 Built-in cabinets and work surfaces
Built-in cabinets, counters and work surfaces shall be accessible, including: patient wardrobes, nurse’s stations, administrative centers, reception desks, medicine preparation areas, laboratory...
-
M305.2.6 Gripping Surfaces (Section-by-Section Analysis)
The proposed rule did not provide any specific requirements regarding gripping surfaces on transfer supports....
-
11B-233.3.1.2.6.1 Single building with one common (lobby) entrance
required access to multifamily dwelling units, in a single building with one common (lobby) entrance, located on a site with difficult terrain conditions or unusual characteristics: All ground...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...