Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
Search Results "High Speed Rail"
-
707.7.2 Characters
-
11B-707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
§ 37.42(e)(2)
., where such a clearance would create an insurmountable gap on a mini-high platform or where the physical structure of an existing station does not allow such clearance), barriers must...
-
A4.6.3 PARKING SPACES
High-top vans, which disabled people or transportation services often use, require higher clearances in parking garages than automobiles....
-
§ 37.42(e)(2)
., where such a clearance would create an insurmountable gap on a mini-high platform or where the physical structure of an existing station does not allow such clearance), barriers must...
-
11B-707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1220 mm) maximum and the low forward reach shall be 15 inches (380 mm) minimum above the finish floor or...
-
How to Remove and Install a Toilet from American Standard
How to remove an existing toilet and replace with a new high-efficiency American Standard toilet....
-
Ohio Gratings Informational Video
You'll find their aluminum and steel products on bridge decks, walkways and incorporated into high end architectural designs....
-
Attachment C: HUMBOLDT COUNTY, CA
Grievance Procedure under The Americans with Disabilities Act
Within 15 calendar days after receipt of the appeal, the County Commissioner/ other appropriate high-level official or [his/her] designee will meet with the complainant to discuss the complaint...
-
Panda S.85 All Aluminum Slim Profile Lift and Slide System
The profiles are made using high tensile 6063-T5 aluminum extrusions for superior strength....
-
Inpro Corporation IPC® HR9 Northern Hardwoods® Real Wood Handrail
Benefits Design interior environmentswith a number of stain colors or unfinished poplar Coated with a low-VOC UV-protective clear finish Coordinate with Northern Hardwoods chair rails...
-
1008.2 Accessible Routes
Where accessible routes serve ground level play components, the vertical clearance shall be 80 inches high (2030 mm) minimum....
-
§382.51(a)(6)
The captioning must be high-contrast insofar as is feasible....
-
7. Grab Bars
Are there two horizontal grab bars (one high/one low) along the side of the tub that are at least 24" long for stabilization and aid in transfer from a wheelchair to the fixed tub seat -...
-
4.35.5 Mirror
Where mirrors are provided in dressing rooms of the same use, then in an accessible dressing room, a full-length mirror, measuring at least 18 in wide by 54 in high (460 mm by 1370 mm),...
-
R406.2 Unobstructed Forward Reach
Where a forward reach is unobstructed, the high forward reach shall be 1220 mm (4.0 ft) maximum and the low forward reach shall be 380 mm (1.25 ft) minimum above the finish surface....
-
M303.2.6 Edge Protection
Where wheelchair spaces are provided on a platform raised more than 1 ½ inches (38 mm) in height, edge protection 2 inches (51 mm) high minimum measured from the surface of the platform...
-
407.2.3.2 Car Designations
Tactile characters shall be 2 inches (51 mm) high minimum....
-
1008.2 Accessible Routes
Where accessible routes serve ground level play components, the vertical clearance shall be 80 inches high (2030 mm) minimum....
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
Handrails may be located in a recess if the recess is a maximum of 3 in (75 mm) deep and extends at least 18 in (455 mm) above the top of the rail (see Fig. 39(d))....
-
§ 38.83(a)(1) General
All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying...
