Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
Search Results "High Speed Rail"
-
11B-404.2.10 Door and gate surfaces
-
1015.2 Where required
On the loading side of station platforms on fixed guideway transit or passenger rail systems....
-
11B-404.2.10 Door and gate surfaces
Tempered glass doors without stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch...
-
4.26.2* SIZE AND SPACING OF GRAB BARS AND HANDRAILS
Handrails may be located in a recess if the recess is a maximum of 3 in (75 mm) deep and extends at least 18 in (455 mm) above the top of the rail (see Fig. 39(d))....
-
§ 38.83(a)(1) General
All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying...
-
B. Restrooms
These specifications are derived from requirements for rail vehicles and represent compromises between space needed for use and constraints imposed by vehicle dimensions....
-
III. Handrails and Stanchions
Handrails and Stanchions In addition to the requirements for handrails and stanchions for rapid, light, and commuter rail vehicles, consideration should be given to the proximity of handrails...
-
602.6 Water Flow
The spout shall provide a flow of water 4 inches (100 mm) high minimum and shall be located 5 inches (125 mm) maximum from the front of the unit....
-
407.12.2.1 Unobstructed Side Reach (Section-by-Section Analysis)
Section-by-Section Analysis) This section proposes that, where the operable part is located 10 inches or less behind the vertical reference plane, the operable part must be 48 inches high...
-
Attachment C: HUMBOLDT COUNTY, CA
Grievance Procedure under The Americans with Disabilities Act
Within 15 calendar days after receipt of the appeal, the County Commissioner/ other appropriate high-level official or [his/her] designee will meet with the complainant to discuss the complaint...
-
49 CFR Parts 27 and 37: Transportation for Individuals With Disabilities; Reasonable Modification of Policies and Practices - Preamble
questions related to transit, you may contact Bonnie Graves, Office of Chief Counsel, Federal Transit Administration, same address, Room E56-306, 202-366-0944, bonnie.graves@dot.gov; and, for rail...
-
How to Remove and Install a Toilet from American Standard
How to remove an existing toilet and replace with a new high-efficiency American Standard toilet....
-
Ohio Gratings Informational Video
You'll find their aluminum and steel products on bridge decks, walkways and incorporated into high end architectural designs....
-
Panda S.85 All Aluminum Slim Profile Lift and Slide System
The profiles are made using high tensile 6063-T5 aluminum extrusions for superior strength....
-
707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
11B-707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
308.2.1 Unobstructed
Where a forward reach is unobstructed, the high forward reach shall be 48 inches (1220 mm) maximum and the low forward reach shall be 15 inches (380 mm) minimum above the finish floor or...
-
§ 37.42(e)(2)
., where such a clearance would create an insurmountable gap on a mini-high platform or where the physical structure of an existing station does not allow such clearance), barriers must...
-
A4.6.3 PARKING SPACES
High-top vans, which disabled people or transportation services often use, require higher clearances in parking garages than automobiles....
-
§ 37.42(e)(2)
., where such a clearance would create an insurmountable gap on a mini-high platform or where the physical structure of an existing station does not allow such clearance), barriers must...
-
11B-707.7.2 Characters
Characters shall be 3/16 inch (4.8 mm) high minimum based on the uppercase letter "I"....
-
Inpro Corporation IPC® HR9 Northern Hardwoods® Real Wood Handrail
Benefits Design interior environmentswith a number of stain colors or unfinished poplar Coated with a low-VOC UV-protective clear finish Coordinate with Northern Hardwoods chair rails...
