The lever of lever actuated latches or locks must be curved with a return to within ½ inch of the door to prevent catching on the clothing of persons during egress. ◼ [2010 ADA Standards...
Search Results "Curved Curb Ramp"
-
11B-404.2.7 Door and gate hardware
-
Clear Floor Space: ADA Standard Section 808.3
alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these spaces where ramp...
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways and ramps, exit passageways, exterior exit stairways and ramps and horizontal exits....
-
EXIT
Exit components include exterior exit doors at the level of exit discharge, interior exit stairways and ramps, exit passageways, exterior exit stairways and ramps and horizontal exits....
-
R305.2.3 Blended Transitions
On blended transitions, detectable warning surfaces shall be placed at the back of curb....
-
Head Room [4.4.2]
Gates, rails, curbs, and other fixed elements, such as planters, can serve as barriers. This is important at open stairways and along sloped walls....
-
11B-608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
Accessible Entrance
When a ramp is added to provide an accessible entrance, the slope of the ramp should be as shallow as possible but not more than 1:12....
-
215 Fire Alarm Systems
Curb ramps no longer required to have detectable warnings except in transportation facilities (see 218 Transportation Facilities. Page 76)...
-
What barriers will it be "readily achievable" to remove?
The Department's regulation contains a list of 21 examples of modifications that may be readily achievable: 1) Installing ramps; 2) Making curb cuts in sidewalks and entrances;...
-
II-3.6100 General
ILLUSTRATION 1: A municipal zoning ordinance requires a set-back of 12 feet from the curb in the central business district....
-
206.2.1 Site Arrival Points
ETA Editor’s Note: Requirements for curb ramps, sidewalks and other elements in the public right of way may be covered by other Federal, State or local standards and regulations....
-
11B-808.3 Clear floor space
alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these spaces where ramp...
-
11B-808.3 Clear floor space
alterations, wheelchair spaces are not required to be located within the defined area of raised jury boxes or witness stands and shall be permitted to be located outside these spaces where ramp...
-
11B-407.4.10 Support rail
Support rails in elevator cabs are used in a different way than handrails along a walking surface such as a ramp or stairway....
-
11B-407.4.10 Support rail
Support rails in elevator cabs are used in a different way than handrails along a walking surface such as a ramp or stairway....
-
Accessible Slopes
For a ramp the maximum running slope allowed is 1:12. That means for every inch of height change there should be at least 12 inches of ramp run....
-
1007 Miniature Golf Facilities
covers miniature golf courses and contains specifications for accessible routes that take into account design conventions for miniature golf courses, such as carpeted play surfaces and curbs...
-
Side Reach [§308.3]
Fuel Dispensers The operable parts of fuel dispensers located on existing curbs can be up to 54” high....
-
Elevated Play Components
Play areas with 20 or more elevated components must use ramps to connect a minimum of 25 percent of those components. ...
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
Obstructed High Reach: ADA Standard Section 308.3.2
Section 308.3.2 covers the current ADA Standards for obstructed high side reach.
-
11B-308.3.2 Obstructed high reach
Operable parts of fuel dispensers shall be permitted to be 54 inches (1372 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...