These measures include, for example, removal of obstructing furniture or vending machines, widening of doors, installation of ramps, providing accessible signage, widening of toilet stalls...
Search Results "Curved Curb Ramp"
Commonly Searched Documents
-
§ 36.304(c)(3)
-
11B-1002.4.3 Gaps
Exception: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
1002.4.3 Gaps
EXCEPTION: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
Why are surface characteristics specified?
Transportation Institute at The Pennsylvania State University compared the slip-resistance needs of persons with mobility impairments and those without disabilities walking on level and ramped...
-
1002.4.3 Gaps
EXCEPTION: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
Some existing measurement protocols
system and waviness index, but these standards are not mandated for testing for accessibility, nor are there any standards for accessibility that can be tested other than overall slope of ramps...
-
Turning Space [§304]
dwelling units (all rooms on an accessible route) patient bedrooms holding and housing cells saunas and steam rooms raised courtroom stations served by ramps...
-
11B-1002.4.3 Gaps
Exception: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
11B-1002.4.3 Gaps
Exception: Where compliance is not operationally or structurally feasible, ramps, bridge plates, or similar devices complying with the applicable requirements of 36 CFR 1192.83(c) shall...
-
Handrails, Grab Bars, and Tub and Shower Seats [4.26]
Handrails, Grab Bars, and Tub and Shower Seats [4.26] ADAAG 4.26 provides technical requirements for: handrails at ramps [4.8] and stairs [4.9] grab bars at water closets...
-
FOREWORD
Vertical Alignment/Crest Vertical Curves-Recumbent bicyclists had a required length of a crest vertical curve of 46.7 m (153 ft), less than the AASHTO value....
-
Pemko 193 Slip resistance
By slip resistance I am assuming it will meet the coefficient of friction requirement of 0.8 if installed on a ramp. Thank you -Brian...
-
1005.3 Edge Protection
In such a design, curbs or barriers are not required....
-
1005.3 Edge Protection
In such a design, curbs or barriers are not required....
-
308.3.1 Unobstructed
Operable parts of fuel dispensers shall be permitted to be 54 inches (1370 mm) maximum measured from the surface of the vehicular way where fuel dispensers are installed on existing curbs...
-
1005.3 Edge Protection
In such a design, curbs or barriers are not required....
- Harmar CPL800H-1400H Hydraulic CPL with Modular Tower
- Inpro ENDURANT® Shower Receptors
- AJW Architectural Products U155 24 oz. Vertical Liquid Soap Dispenser - Surface Mounted
- AJW Architectural Products U144 ABS Soap Dispenser
- Landscape Forms Inc. Parc Vue Trash Receptacle
- American Standard Brandon Centerset Bathroom Faucet
-
R309.5.1 Location
Locating parking meters at the head or foot of the parking space permits deployment of a van side-lift or ramp or the vehicle occupant to transfer to a wheelchair or scooter....
-
Special Technical Provisions for Alterations to Existing Buildings and Facilities [4.1.6(3)]
Section 4.1.6(3) recognizes certain allowances where technical feasibility is encountered, such as steeper slopes for short ramps....