These areas should be considered as a pedestrian walk with a minimum width of 60 in. and a length of approximately 20 ft and with an ADA/ABA - AG maximum slope of 1:48 in both directions...
Search Results "Continuous Width"
-
1.1.7 Measurement of parking areas
-
§ 38.159(d)(4) Orientation
The padded barrier shall extend from a height of 38 inches (965 mm) from the vehicle floor to a height of 56 inches (1420 mm) from the vehicle floor with a width of 18 inches (455 mm), laterally...
-
11B-812.8.7 Location
Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected vehicle space width at the head end of the vehicle space....
-
1010.1.8 Door arrangement
Space between two doors in a series shall be 48 inches (1219 mm) minimum plus the width of a door swinging into the space....
-
11B-812.8.7 Location
Signs shall be permanently posted either immediately adjacent to the vehicle space or within the projected vehicle space width at the head end of the vehicle space....
-
Audible Hall Signals
The Board sought comment on whether a frequency band width should be specified for verbal annunciators (Question 21)....
-
Smooth Surface
Section 404.2.10 requires that swinging doors and gates have a smooth surface on the push side that extends their full width....
-
Areas of Rescue Assistance [4.1.3(9), 4.3.11]
Wheelchair spaces must be located outside required exit widths. The minimum 48 inch width, measured between the leading edge of handrails, provides clearance for assisted evacuation....
-
1017.4 Passing Spaces
This section requires passing spaces to be provided at intervals of 1000 feet maximum where the clear tread width of trails is less than 60 inches....
- Bradley 3 Station Express Deck Lavatory System EXD-3N
- ASI Storage Solutions Traditional Plus Locker
-
1. Executive Summary
would require pedestrian access routes to be provided within pedestrian circulation paths located in the public right-of-way, and would establish proposed technical provisions for the width...
- Whitehall Mfg. WH3740 Ligature Resistant Stainless Steel Basin
- Tork Toilet Seat Cover Dispenser
-
F202.6 Leases
The negotiation of a new lease occurs when (1) the Federal government leases a facility that it did not occupy previously; or (2) an existing term ends and a new lease is negotiated for continued...
-
Handrails Requirement
The handrail requirements in section 505 address specifications for continuity, height, clearance, gripping surface, cross section, fittings, and extensions....
-
Features of Accessible Exam Tables
Removable/adjustable support rails with continuous gripping surfaces 2. 30” X 48” minimum clear floor space adjacent to exam table and adjoining accessible route 3....
-
Accessible Design Benefits Everyone
used by people with disabilities to access computers, private and government organizations have worked to establish flexible guidelines for accessible web pages that permit innovation to continue...
-
EQUIPMENT
Physical growth and development and changes in ability require continuous reevaluation and, as needed, modification of the fit and functionality of equipment for children and youth with...
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
Talking three-dimensional models for way-finding and orientation
Some models provide information in a series of audio layers that are accessed by continuing finger contact with a single part of the model....
-
ADA Checklist for Existing Facilities: Identify barriers and develop a plan
However, these businesses should continue to do as much as they can to become more accessible, based upon changes in resources over time....
-
§ 38.83(b)(2)(i) Requirements
Where provided, each control for deploying, lowering, raising, and stowing the lift and lowering the roll-off barrier shall be of a momentary contact type requiring continuous manual pressure...
-
§ 38.23(b)(2)(i) Requirements
Where provided, each control for deploying, lowering, raising, and stowing the lift and lowering the roll-off barrier shall be of a momentary contact type requiring continuous manual pressure...