A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
Search Results "Continuous Width"
Filters
Commonly Searched Documents
-
1002.4.4.2 Side Entry
-
5.3.3 Transfer Sides Recommendations for M302
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface....
-
1002.4.4.2 Side Entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
1132A.9 Smooth surface
Swinging door or gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Edge Protection
Recommendation: At narrow routes in particular, consider maintenance of adjacent surfaces as raised or flush or wider route widths in consideration of minimum maneuvering and passage requirements...
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
Floor Plan of Elevator Cars [4.10.9]
In alterations, smaller car sizes (minimum 47 inch width and 69 inch length) are permitted in cases of technical infeasibility, including where limited by existing shaft configurations (...
-
Shape and Diameter
A gripping surface width between 1¼ to 1½ inches diameter is specified....
-
Rough Form and Foundation Inspection
slope). 11B-403 Verify forms for sidewalks, ramps, landings, curb ramps and clear floor spaces are correctly installed so proper slopes, cross slopes, widths...
-
4.34.6.7* OVENS
For side-opening ovens, the door latch side shall be next to the open counter space, and there shall be a pull-out shelf under the oven extending the full width of the oven and pulling out...
-
1.1.12 Ramp cross slope
slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the cross slope at these two locations using the horizontal ramp width...
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-1002.4.4.2 Side entry
A 32 inch (815 mm) clear opening will not provide sufficient width when entered through a turn into an amusement ride....
-
11B-704.2.1.2 Forward approach
If an additional 6 inches (152 mm) in width of clear floor space is provided, creating a clear floor space of 36 inches by 48 inches (914 mm by 1219 mm), the enclosure may extend more than...
-
Where do I measure for a handrail extension?
Extensions shall return to a wall, guard, or the landing surface, or shall be continuous to the handrail of an adjacent stair flight....
-
Wagner Instruments Mark-10 M4 Digital Force Gauge
Power Requirements Continuous operation with 110 or 220 Vac power adapter. Rechargeable NiMH battery for up to 30 hours continuous use....
-
Living Earth Crafts Essex™ Pedicure Chair
options Relaxor heat and massage Wide variety of upholstery and trim color options Power drain pump Pedicure Dimensions Height - 46" (119 cm) Width...
-
Sargent HC 8800 Rim Exit Device
The HC8800 device is designed for standard width stile applications on metal doors. The Hurricane Code Hardware has been accepted by Dade County, Florida....
-
Equipment and furniture.
The ANPRM explained that free-standing equipment was already addressed in the regulations in several different contexts, but that since covered entities continue to raise questions about...
-
THIRD CAUSE OF ACTION
Plaintiffs are informed, believe, and thereon allege that Defendant and its agents and employees have violated and continue to violate sections 49.60.010 et seq. of the Revised Code of Washington...
-
American Safety Tread Co., Inc. Type G500R Stairway Nosing Replacement
Width: 9" Lip: 1-3/8" at 90° angle Thickness: 1/4" Anchor Options: Drilled for screws....
-
American Safety Tread Co., Inc. Type SG4702 Stairway Nosing Replacement
Width: 5" Lip: 1-3/8" at 83° angle Thickness: 1/4" Anchor Options: Drilled for screws....
-
Takeform Fusion Signage Overheads Type C
Choose from 44" and 88" width, wall mount, flush ceiling mount, or suspended; ceiling mount and suspended overheads are double-sided....
