Toilet compartment doors, including door hardware, shall comply with 404, except that if the approach is to the latch side of the compartment door, clearance between the door side of the...
Search Results "Side Grab Bar"
Commonly Searched Documents
-
604.8.2.2 Doors
-
11B-505.2 Where required
Handrails shall be provided on both sides of stairs and ramps. Exceptions: 1. ...
-
11B-505.2 Where required
Handrails shall be provided on both sides of stairs and ramps. Exceptions: 1. ...
-
11B-812.7.1 Location
Access aisles at vehicle spaces shall not overlap the vehicular way and may be placed on either side of the vehicle space they serve except for van accessible spaces which shall have access...
- Slope : Intercept
- American Specialties Heavy Duty Stainless Steel Soap Dish with Rectangular Solid Bar 0398
-
BINDING EFFECT
This will bar any person who is a member of the Settlement Class from prosecuting or maintaining any claim or action released under the terms of the Settlement Agreement....
-
A4.34.6.8 REFRIGERATOR/FREEZERS
Side-by-side refrigerator/freezers provide the most usable freezer compartments....
-
604.8.2.2 Doors
Toilet compartment doors, including door hardware, shall comply with 404, except that if the approach is to the latch side of the compartment door, clearance between the door side of the...
-
407.12 Reach Height
At least one of each type of operable part of stationary ICT shall be at a height conforming to 407.12.2 or 407.12.3 according to its position established in 407.12.1 for a side reach or...
-
11B-231.4.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....
-
807.2.3 Beds
Where beds are provided, clear floor space complying with 305 shall be provided on at least one side of the bed....
-
807.2.3 Beds
Where beds are provided, clear floor space complying with 305 shall be provided on at least one side of the bed....
-
11B-604.8.1.2 Doors
A door pull complying with Section 11B-404.2.7 shall be placed on both sides of the door near the latch. ...
-
Perpendicular Curb Ramps (R304.2) (Section-by-Section Analysis)
The flared sides are part of the pedestrian circulation path, but are not part of the pedestrian access route. The slope of the flared sides is measured parallel to the curb line....
-
11B-404.2.4.1 Swinging doors and gates
CLEARANCES AT MANUAL SWINGING DOORS AND GATES TYPE OF USE MINIMUM MANEUVERING CLEARANCE Approach direction Door or gate side...
-
Fire Rings, Grills, Fireplaces, and Woodstoves [1011.2, 1011.3, and 1011.5]
The usable sides of these elements are the sides that can be used for building a fire or for cooking....
-
Door Maneuvering Clearance
, hinge side)....
-
1013.2 Where required
to the floor or grade below at any point within 36 inches (914 mm) horizontally to the edge of the open side....
-
404.2.4.2 Doorways without Doors or Gates
unless noted) From front 48 inches (1220 mm) 0 inches (0 mm) From side 1 42 inches (1065 mm)...
-
1015.2 Where required
vertically to the floor or grade below at any point within 36 inches (914 mm) horizontally to the edge of the open side....
-
4.34.6.7* OVENS
For side-opening ovens, the door latch side shall be next to the open counter space, and there shall be a pull-out shelf under the oven extending the full width of the oven and pulling out...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-231.4.1 Cubicles and counters
At least 5 percent, but no fewer than one, of cubicles shall comply with Section 11B-902 on both the visitor and detainee sides....