The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
Search Results "Seat Width"
Filters
Commonly Searched Documents
-
5.1.4 Transfer Surface Height Measurement
-
Accessible Sidewalks 2: Pedestrians with Ambulatory Impairments
Requires the Registered User plan or above. Login! -
Chapter 3: Study findings
[See subsections ...]
-
4.34.5.4 BATHTUBS
If a bathtub is provided, then it shall have the following features:
-
221.2.1.1 General Seating
221.2.1.1 General Seating. Wheelchair spaces complying with 802.1 shall be provided in accordance with Table 221.2.1.1....
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
AMUSEMENT RIDE SEAT
[DSA-AC] A seat that is built-in or mechanically fastened to an amusement ride intended to be occupied by one or more passengers....
-
5.4.7 Transfer Support Gripping Surface Clearance Recommendation for M301 and M302
gripping surface would be appropriate for transfer supports on diagnostic equipment used by patients in a supine, prone, or side-lying position, and diagnostic equipment used by patients in a seated...
-
Midmark Ritter 223 Barrier-Free® Power Examination Table
Help them help themselves with features such as: Power height 400-pound patient weight capacity 18-inch to 37-inch seat height adjustment Foot control standard Length with...
-
4. Wheelchair seat depth
Wheelchair seat depth For this study, wheelchair seat depth was calculated as the horizontal distance from the proximal (i.e., towards the rear) edge to the distal (i.e., towards the...
-
M305.2.2 Length (Section-by-Section Analysis)
inches deep, the Committee recommended requiring a transfer support to extend horizontally along the side of the patient table at the designated transfer location for at least the minimum width...
-
Requirement 6. Reinforced walls for grab bars.
that all premises within covered multifamily dwelling units contain reinforcements in bathroom walls to allow later installation of grab bars around toilet, tub, shower stall and shower seat...
-
7. Seat Transfer
Are the roll-in showers free of doors that would impede wheelchair transfer onto the seat? [ADA Stds. 4.21.8] Yes __ No __ N/A __ Comments: _______________________________________...
-
Midmark Ritter 222 Barrier-Free® Power Examination Table
Help them help themselves with features such as: Power height Manual back with air spring assist 400-pound patient weight capacity 18-inch to 37-inch seat height adjustment...
-
5.4.4 Transfer Support Distance from Transfer Surface Recommendations for M301 and M302
appropriate for the location and size of transfer supports on diagnostic equipment used by patients in a supine, prone or side-lying position, and diagnostic equipment used by patients in a seated...
-
Section C: Exterior Route
Ward:__________ Precinct:__________ Staff:________________ Date:________ Time:_________ Address:_______________________________________ Location...
-
203.9 Employee Work Areas
Spaces and elements within employee work areas shall only be required to comply with 206.2.8, 207.1, and 215.3 and shall be designed and constructed so that individuals with...
-
203.9 Employee Work Areas
203.9 Employee Work Areas. Spaces and elements within employee work areas shall only be required to comply with 206.2.8, 207.1, and 215.3 and shall be designed and constructed so...
-
Handrails [§405.8, §505]
Handrails [§405.8, §505] Handrails are required on both sides of ramps with a rise greater than 6”. The Standards do not require lower handrails serving children except at ramps...
-
Plan 1B: 13-Foot Wide Accessible Guest Room
Features include a standard bathtub with a seat, comparable vanity, clothes closet with swinging doors, and door connecting to adjacent guest room....
-
Associated
Dispensers associated with the use of a water closet and allowed to overlap the water closet clearance include seat cover, feminine hygiene product, disposal bag, and toilet paper dispensers...
-
M305.2.8 Fittings (Section-by-Section Analysis)
A different manufacturer stated that its seated diagnostic equipment uses armrests as transfer supports, which can be pushed back toward the rear of the equipment to allow entry....
