9.1 The precision and bias of the computed PRI is limited by the procedures used in making the longitudinal profile measurement. 9.2 For the effects of the precision and bias of the measured...
Search Results "Unit of Measurement"
Filters
Commonly Searched Documents
-
9. Precision and Bias
-
604.3.1 Size
Clearance around a water closet shall be 60 inches (1525 mm) minimum measured perpendicular from the side wall and 56 inches (1420 mm) minimum measured perpendicular from the rear wall....
-
Clearance: ADA Standard Section 804.2
Clearances are measured from the furthest projecting face of all opposing base cabinets, counter tops, appliances, or walls, excluding hardware....
-
11B-805.4 Examination, diagnostic and treatment rooms
treatment rooms refer to all patient care areas and include but are not limited to: exam rooms, treatment rooms, imaging rooms, operating rooms, emergency rooms, post anesthesia recovery rooms/units...
-
Just Manufacturing Deck Mounted Classroom Faucet with Vandal Resistant Lever Handle
Brass quick compression stem unit. Valve has replaceable seat. Replaceable reinforced nitrile rubber packing. Replaceable Buna-N seat washers....
-
Just Manufacturing Classroom Concealed Ledgemount Single Handle Restricted Swing Faucet
Classroom faucets feature rigid spouts, or restricted swing spouts, providing preventative measures against wet counter tops in the classroom....
-
36 CFR Part 1191 ABA Accessibility Guidelines, Outdoor Developed Areas
Billing Code 8150‒01-P ARCHITECTURAL AND TRANSPORTATION BARRIERS COMPLIANCE BOARD 36 CFR Part 1191 RIN 3014-AA22 Architectural Barriers Act Accessibility Guidelines;...
-
Sub-Committee Summary of Scope for Recommendations
Sub-Committee Summary of Scope for Recommendations Though sometimes avoided, all patients should have their weight taken as it is a basic screening measurement....
-
Grab bar clearance
These units stick out ¼" or so. ANSI 117.1 allows it in 609.3 (2)....
-
Station 1-Physical Characteristics
At the first station, the physical characteristics of active participants and their equipment were measured (figure 26)....
-
Selection of Variables
For this survey we suggest variables that fall into five categories: basic body size descriptors reach and functional reach measurements arm and hand strength measurements...
-
C. Election Judge and Poll Worker Training
, including: (a) why such measures are necessary; (b) how the measures must be implemented (e.g., how to install ramps, the placement of mats over (and not in front of) thresholds); and...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
11B-810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2438 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-703.4.1 Height above finish floor or ground
Tactile characters on signs shall be located 48 inches (1219 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest Braille cells and 60 inches (1524...
-
BS8300:2001 Research
It is also not clear what was measured if the chair had no armrests or slanted armrests....
-
§ 36.304(c)(1)
(1) First, a public accommodation should take measures to provide access to a place of public accommodation from public sidewalks, parking, or public transportation....
-
Sec.36.304(c)(1)
(1) First, a public accommodation should take measures to provide access to a place of public accommodation from public sidewalks, parking, or public transportation....
-
Toilet Rooms and Bathing Rooms: ADA Standard Section 213.2
Section 213.2 covers scoping requirements in the current ADA Standards for toilet rooms and bathing rooms.
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
405.3 Cross Slope
Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
R308.1.1.1 Dimensions
Boarding and alighting areas shall provide a clear length of 2.4 m (8.0 ft) minimum, measured perpendicular to the curb or street or highway edge, and a clear width of 1.5 m (5.0 ft) minimum...
