This guideline was developed by the Low Vision Design Committee of the National Institute of Building Sciences (NIBS) through initial funding from the U.S....
Search Results "Designated Aisle Seat (Assembly)"
- Design Guidelines for the Visual Environment
-
Picnic Units
When designing picnic areas, remember locating 20 percent of the units on an outdoor recreation access route is only a minimum requirement....
-
1007.1 Accessible means of egress required
In assembly spaces with sloped floors, one accessible means of egress is required from a space where the common path of travel of the accessible route for access to the wheelchair spaces...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
Width Recommendations for M302 The Committee recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated...
-
M303.2.1 Orientation
Wheelchair spaces shall be designed so that a patient seated in a wheelchair orients in the same direction that a patient not seated in a wheelchair orients when the diagnostic equipment...
-
M303.2.1 Orientation
Wheelchair spaces shall be designed so that a patient seated in a wheelchair orients in the same direction that a patient not seated in a wheelchair orients when the diagnostic equipment...
-
II. ENFORCING THE ADA PART 2
The ADA was designed to address situations such as these....
- Figure 1009.2.2 Pool Lift Seat Location – Drawing from the U.S. Access Board
-
5.5.1 Armrest Provision for M302
5.5.1 Armrest Provision for M302 Description: Diagnostic equipment used by patients in a seated position such as exam chairs typically have armrests....
-
11B-604.9 Water closets and toilet compartments for children's use
Water Closet Centerline 12 inches (305 mm) 12 to 15 inches (305 to 381 mm) 15 to 18 inches (381 to 457 mm) Toilet Seat...
- Inpro Corporation SignScape® Regulatory Signs
-
11B-703.4.2 Location
In this section, the term “wall space” refers to any type of partition assembly or adjacent surface of sufficient dimension where a sign can lay flat, including glass partitions or sidelites...
-
11B-703.4.2 Location
In this section, the term “wall space” refers to any type of partition assembly or adjacent surface of sufficient dimension where a sign can lay flat, including glass partitions or sidelites...
- Otis Elevator Braille and Safety Signs
-
Parking
Parking areas may lack accessible parking spaces with adequate access aisles and signs, or may be on a sloped surface....
-
Monitoring and Fees
Monitoring and Fees – During the first five years of the Compliance Period, Plaintiffs may conduct semi-annual inspections of the City’s drawings and/or designs regarding the pedestrian...
-
11B-604.9 Water closets and toilet compartments for children's use
5 through 8 Ages 9 through 12 Water Closet Centerline 12 inches (305 mm) 12 to 15 inches (305 to 381 mm) 15 to 18 inches (381 to 457 mm) Toilet Seat...
-
11B-604.9 Water closets and toilet compartments for children's use
Water Closet Centerline 12 inches (305 mm) 12 to 15 inches (305 to 381 mm) 15 to 18 inches (381 to 457 mm) Toilet Seat...
-
§ 382.39 Provision of services and equipment
Where these means are unavailable, assistance in boarding aircraft with 30 or fewer passenger seats shall be provided as set forth in Sec. 382.40, and assistance in boarding aircraft with...
- Delta Toilet Installation Video
-
§ 382.40 Boarding assistance for small aircraft
(a) Paragraphs (b) and (c) of this section apply to air carriers conducting passenger operations with aircraft having 19-30 seat capacity at airports with 10,000 or more annual enplanements...
-
H1
H1. If a sign is provided at the toilet room entrance (e.g. Men, Women, Boys, Girls, etc.), is a sign with raised characters and Braille mounted on the wall adjacent to the latch?...
-
12147(b) Special rule for stations
(b) Special rule for stations
