The vertical alignment of joints in concrete, asphalt, or board surfaces on trails can be tread obstacles....
Search Results "Concrete Surface"
-
1017.5 Tread Obstacles
-
A4.29.2 Detectable Warnings on Walking Surfaces
A4.29.2 Detectable Warnings on Walking Surfaces. The material used to provide contrast should contrast by at least 70%....
-
AIAU Accessible Architecture: Designing for Success (Parts 1-3)
In Part 3, review the details and best practices regarding ADA compliance concerning singage, counters, dining and work surfaces, guest rooms, pools and (everyone’s favorite) bathrooms....
-
Disability Access - Tips for the small business
California Commission on Disability Access http://www.ccda.ca.gov
-
1132A.4, Item 1
., concrete, brick, flagstone) serving primary entry doors and required exit doors are limited to not more than ½ inch (12.7 mm) of change in height between floor surfaces....
-
1132A.4, Item 1
., concrete, brick, flagstone) serving primary entry doors and required exit doors are limited to not more than ½ inch (12.7 mm) of change in height between floor surfaces....
-
Compilation of Instruments and Measurement Methods for Surface Accessibility
Compilation of Instruments and Measurement Methods for Surface Accessibility During the course of this project the following information was developed as background information to assist...
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
M305.2 Transfer Supports (Section-by-Section Analysis)
This is an introductory section. As discussed above in Section IV.E.1. (Significant Changes – Transfer Supports), the Access Board strengthened the transfer support requirements and...
-
5.4 Transfer Supports
5.4 Transfer Supports.
-
5.4 Transfer Supports Recommendations
5.4 Transfer Supports Recommendations
-
M305.2 Transfer Supports
Transfer supports shall comply with M305.2.
-
3.2 Getting on the Table
Additional helpful features include an extra-wide top surface and higher weight capacity for larger people, adjustable side rails, positioning straps, and foot and leg supports that can...
-
(c) Thresholds at patio, deck or balcony doors
The final Guidelines provide that exterior deck, patio, or balcony surfaces should be no more than 1/2 inch below the floor level of the interior of the dwelling unit, unless they are constructed...
-
What materials may satisfy ADAAG requirements?
In new construction and alterations, surface materials must be specified to be slip-resistant....
-
Transfer Access [1014.2.1]
The surface of the clear ground space must be firm and stable....
-
11B-809.8 Doors
in height between floor surfaces....
-
Boost Your Business - Chapter 4 - Ramps
Boost Your Business - Chapter 4 - Ramps
-
APPENDIX C
What was your pain/discomfort value associated with this surface (circle)?...
-
1132A.4, Item 4
Secondary exterior doors onto decks, patios or balcony surfaces constructed of impervious materials (e.g., concrete, brick, flagstone) may have a maximum change in height from the interior...
-
Unified Facilities Guide Specifications
Unified Facilities Guide Specifications In Section 02752, Portland Cement Concrete Pavement for Roads and Site Facilities, published by the National Institute of Building Sciences, it...
-
5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position
5.3.1 Permitted Obstructions to Transfer Sides for Equipment Used by Patients in a Supine, Prone, Side-Lying or Seated Position. A 3-inch maximum obstruction is permitted at transfer...
-
Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis)
Detectable Warning Surfaces on Curb Ramps (Section-by-Section Analysis) When the Access Board issued the 1991 ADAAG, the guidelines contained a requirement for detectable warning surfaces...
-
Jean Tessmer
I have used this tool for concrete, asphalt, and raised board walk construction work on federal and private commercial projects....
