The Guidelines at Requirement 4 provide that thresholds at doors, including sliding door tracks, may be no higher than 3/4 and must be beveled with a slope no greater than 1:2....
Search Results "Shower Slope"
-
19.1 Q. If a sliding door track has a threshold of 3/4, does this trigger requirements for ramps?
-
3a.
If yes, is a ramp or sloped hallway provided? Yes _____ No _____ If yes, go to question E1-4. Note: A ramp, lift, or elevator can be used to provide access to floor levels....
-
5.8.2.8 Knee and Toe Clearance Recommendations Summary
platform will be moved to 34 inches above the ground, and then the clearance dimensions will be measured just as they would be on any stationary piece of equipment, with allowance for slopes...
-
1132A.4.1 Thresholds
Thresholds with a change in height between ¼ inch (6.35 mm) and 3/4 inch (19.05 mm) shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)...
-
1007.3.1 Start of Play
A clear floor or ground space 48 inches (1220 mm) minimum by 60 inches (1525 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
-
RV Parking Spaces Within Camping Units With Mobility Features and RV Pull-Up Spaces at Dump Stations [F244.2.3.2.1 and F244.4]
RV parking spaces within camping units with mobility features and RV pull-up spaces at dump stations must comply with the technical requirements for width, surface, and slope of RV spaces...
-
1007.3.1 Start of Play
A clear floor or ground space 48 inches (1220 mm) minimum by 60 inches (1525 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
-
11B-1007.3.1 Start of play
A clear floor or ground space 48 inches (1219 mm) minimum by 60 inches (1524 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
-
1010.1 Turning Space
A circular turning space 60 inches (1525 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions. ...
-
A4.8.4 Landings
Level landings are essential toward maintaining an aggregate slope that complies with these guidelines....
-
11B-1007.3.1 Start of play
A clear floor or ground space 48 inches (1219 mm) minimum by 60 inches (1524 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
-
11B-1007.3.1 Start of play
A clear floor or ground space 48 inches (1219 mm) minimum by 60 inches (1524 mm) minimum with slopes not steeper than 1:48 shall be provided at the start of play....
-
1016.8 Resting Intervals
This section contains the technical requirements for the length (1016.8.1), width (1016.8.2), and slope (1016.8.3) of resting intervals; and for a turning space (1016.8.4) where resting...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
Using the Beach Access Route Exceptions [1018.1, Exceptions 1 and 2]
Removable Beach Access Route Requirements Removable beach access routes are not required to comply with the specific requirements for running slope, cross slope, resting intervals, and...
-
R105 Definitions (Section-by-Section Analysis)
The proposed guidelines define the following terms: accessible, alteration, blended transition, cross slope, curb line, curb ramp, element, facility, grade break, operable part, pedestrian...
-
Grade (R302.5) (Section-by-Section Analysis)
Grade (R302.5) (Section-by-Section Analysis) Grade is the slope parallel to the direction of pedestrian travel....
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
Permanent seats shall be positioned at the head end of the bathtub.14 Nineteen-inch high shower compartment seats are accessible: 610.3 Shower Compartment Seats....
-
When Ramps Are Required
A ramp run is a length of a continuous sloped surface that is ascending or descending....
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. Exception: Parallel curb ramps shall not be required to comply with Section 11B-406.5.3....
-
Exceptions When Conditions Do Not Permit Full Compliance
The regulatory negotiation committee report used the example of constructing a portion of a trail in a steeply sloped area, where complying with the provision for running slope would require...
-
Recommended Objective Test Method and Performance Specifications
Performance Specifications The objective test method using the Rotational Penetrometer is recommended because it provides valid and reliable measurements of surface firmness and stability on slopes...
-
K. SIDEWALKS
streets, roads, and highways under the jurisdiction of Humboldt County that have not been constructed or altered since January 26, 1992; and (2) a timetable to provide curb ramps or other sloped...
-
K. SIDEWALKS
Within three (3) years of the entry of this Consent Decree, the County will provide curb ramps or other sloped areas complying with the applicable architectural standards as permitted by...