Carpeting can significantly increase the amount of force needed to propel a wheelchair over a surface....
Search Results "Curb Ramp Surface"
-
Carpet [4.5.3]
-
Tile Tech Pavers® IPE Deck Tiles
IPE Deck Tiles are designed for constructing raised wood decks over exterior surfaces such as rooftops, terraces and plazas, in both residential and commercial applications....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
11B-403.1 General
Walking surfaces that are a part of an accessible route shall comply with Section 11B-403....
-
403.1 General
Walking surfaces that are a part of an accessible route shall comply with 403....
-
4.1.2(4)
(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
-
4.9.4(4)
(4) Gripping surfaces shall be uninterrupted by newel posts, other construction elements, or obstructions....
-
4.1.1(4)
(4) Ground surfaces along accessible routes and in accessible spaces shall comply with 4.5....
-
Slope [4.3.7]
Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage....
-
M301.2.1 Transfer Surface Height
The accessory or installation would result in decreasing the distance between the transfer surface and the surface where the mobility device is located....
-
Filter Pave™ Porous Paving for Stormwater Management Informational Video
Filter Pave™ Porous Paving for Stormwater Management Informational Video
-
Features of Accessible Parking Spaces
Parking space identification sign with the international symbol of accessibility complying with 703.7.2.1 mounted 60 inches minimum above the ground surface measured to the bottom of the...
-
1005.3.2 Extended Ground or Deck Surface
1005.3.2 Extended Ground or Deck Surface. The ground or deck surface shall extend 12 inches (305 mm) minimum beyond the inside face of the railing....
-
T404.3 Ramps and Bridgeplates
platform is greater than 2 inches (51 mm) horizontally or 5/8 inch (16 mm) vertically when measured at 50 percent passenger load with the vehicle at rest, non-rail vehicles shall provide ramps...
-
Slope
The 2010 Standards provide, at section 403.3, that the cross slope of walking surfaces not be steeper than 1:48....
-
1.1.4
1.1.4 A maximum overall design running slope for exterior accessible ramps of 7.5% (1:13.3 or 1:13) is recommended....
-
How to Measure Ramp Handrail Extensions
This short video considers some of the most common factors required for measuring ramp handrail extensions for compliance surveys....
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface....
-
Tile Tech Pavers® Oceanic™ Series - Wave-Pave™
pavers can also be manufactured with various design mixes such as crushed seashells, granite chips and recycled glass which are then honed and shot blasted for a unique and slip resistant surface...
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
11B-405.7.5 Doorways
Doors, when fully open, shall not reduce the required ramp landing width by more than 3 inches (76 mm)....
-
5.8.1.2.1 Ramped Entry Slope Recommendations
5.8.1.2.1 Ramped Entry Slope Recommendations The Committee recommends that raised platforms have a ramp with slopes that do not exceed the following: At 0 to 1½ inches, the slope...
