Bus shelters shall be connected by an accessible route complying with Section 11B-402 to a boarding and alighting area complying with Section 11B-810.2....
Search Results "Patient Change Area"
Filters
Commonly Searched Documents
-
11B-810.3 Bus shelters
-
Balco FMS-A and FMS-V Roll-Up Floor Mat
Balco's Premium Roll-Up Mat is a Vinyl Hinge Construction with Standard Mill Finish Aluminum; Clear Anodized, and Medium Bronze Anodized Finishes Available. Balco's versatile series...
-
810.3 Bus Shelters
Bus shelters shall be connected by an accessible route complying with 402 to a boarding and alighting area complying with 810.2. Figure 810.3 Bus Shelters...
-
9. I do not need to provide access to my rental office because I do not have disabled tenants in my housing facility.
All common use areas serving covered multifamily dwellings are also subject to the accessibility requirements in Chapter 11A, and the accessibility and reasonable accommodations requirements...
-
11B-810.3 Bus shelters
Bus shelters shall be connected by an accessible route complying with Section 11B-402 to a boarding and alighting area complying with Section 11B-810.2....
-
What constitutes a “passenger loading zone”?
Only those areas that are specifically designed or designated for passenger loading are considered “passenger loading zones” under the Standards....
-
M303.2.6 Edge Protection (Section-by-Section Analysis)
(Significant Changes – Edge Protection), the final rule requires platforms with wheelchair spaces that are raised more than 1½ inches in height to provide a minimum 2-inch-high edge protection...
-
1007.2, Item 10
Exterior area for assisted rescue complying with Section 1007.7....
-
M303.2 Wheelchair Spaces
Wheelchair spaces complying with M303.2 shall be provided at diagnostic equipment.
-
M305.3.3 Fittings
Standing supports shall not rotate within their fittings.
-
M303.2.3 Depth
The depth of wheelchair spaces shall comply with M303.2.3.
-
11B-805.2.3 Turning space
Turning space complying with Section 11B-304 shall be provided within the room.
-
M302.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided and shall comply with M305.5.
-
M302.2.4 Transfer Sides
Options to transfer from a mobility device shall be provided on two adjoining sides of transfer surfaces. EXCEPTION: Options to transfer to or from a mobility device onto...
-
1. MOVING (MOBILITY / PHYSICAL / MOTOR – LIMITED OR NO ABILITY GRAB, GRIP, LIFT, HOLD, ETC)
1.1. Uses Wheelchair Scooter Walker Cane Braces Prosthesis Service Animal - Overnight stay w/...
-
805.2 Turning Space
Turning space complying with 304 shall be provided within the room.
-
805.2 Turning Space
Turning space complying with 304 shall be provided within the room.
-
M303.2 Wheelchair spaces (Section-by-Section Analysis)
This is an introductory section.
-
5.2.3 Transfer Surface Measurement
5.2.3 Transfer Surface Measurement. The transfer surface should be measured from the center-point of each side of the transfer surface.
-
5.3.3.1 Transfer Sides for Exam Chairs with Fixed Footrests
5.3.3.1 Transfer Sides for Exam Chairs with Fixed Footrests. The 17 inch minimum depth and 21 inch minimum width should be located on both sides of examination chairs with a fixed...
-
805.2 Turning Space
805.2 Turning Space. Turning space complying with 304 shall be provided within the room.
-
M302.2.3 Transfer Sides
The transfer surface shall be located to provide options to transfer from a mobility device onto one short side (depth) and one long side (width) of the surface. Each transfer side...
-
M303.2.3 Depth
Where wheelchair spaces can be entered from the front or rear, the wheelchair space shall be 48 inches (1220 mm) deep minimum. Where wheelchair spaces can be entered only from the...
-
M302.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided. Where the incline of the back support can be modified while in use, head and...
