Standards, require operable parts on accessible elements, along accessible routes, and in accessible rooms and spaces to comply with the technical requirements for operable parts, including height...
Search Results "Head Height"
Filters
Commonly Searched Documents
-
205 and 309 Operable Parts
-
6.3 Minority Reports
6.3 Minority Reports Because the Advisory Committee did not achieve consensus on the recommendation for a minimum transfer surface height standard, U.S....
-
407.12.3.2.2 Knee and Toe Space (Section-by-Section Analysis)
First, toe space with a reduced clear height of 9 inches (rather than 27 inches) would be permitted for a depth of no more than 6 inches....
-
4.34.4 CONSUMER INFORMATION
the owner or occupant of a dwelling, the following consumer information shall be provided in each adaptable dwelling unit available for occupancy: (1) Notification of the alternate heights...
-
III-7.5165 Signage
. , men's and women's rooms, room numbers, exit signs) must have raised and Brailled letters; must comply with finish and contrast standards; and must be mounted at a certain height and...
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-608.3 Grab bars
Where multiple grab bars are used, required horizontal grab bars shall be installed at the same height above the finish floor....
-
11B-411.2.1.2.3 Accessibility function button
The International Symbol of Accessibility shall comply with Section 11B-703.7.2.1, and shall be 5/8 inch (15.9 mm) minimum in height. The indication shall be three raised dots....
-
Question 16
What are appropriate bed heights to ensure accessibility by individuals with mobility disabilities and should there be requirements for mattresses to ensure that the height of the mattress...
-
viii. Hospital beds and gurneys
In order to permit transfers by individuals with mobility disabilities, including those using wheelchairs, accessible height-adjustable beds would allow persons using wheelchairs and other...
-
Mirrors [4.19.6]
The mounting height of the bottom of mirrors at accessible lavatories (40 inches maximum above the floor) is based on the standard eye level range of adults seated in wheelchairs (43 to...
-
11B-225.2.3 Library book stacks
ETA Editor's Note The ADA Advisory identifies library shelving as self-service shelving, which does not have a height limitation....
-
Specifications for Alternate Roll-in Shower Controls
Showers, like bathtubs, are required to be equipped with movable shower spray units that can be used as a fixed-position shower head and a hand-held shower (608.6)....
-
5.3.2.1 Transfer Sides Recommendation for Stretchers
The location of the transfer side is on the patient right or left roughly midway between the two ends (head and foot)....
-
H. Men's Spa and Fitness Center Locker Room
Defendants will convert the accessible shower compartment in the Men's Spa Dressing Room and Men's Fitness Center Locker room to a compliant shower including compliant controls, faucets, shower head...
-
Design Guidelines for Environmental Illness
As discussed above, under the preamble heading "Bias Toward Wheelchair Users," the Act's requirements primarily are directed to providing housing that is accessible to individuals with mobility...
-
Grab Bars [4.20.4] and Controls [4.20.5]
Seats at the head of the tub are limited to a 15 inch depth so that back support is available from the side wall (which is why grab bars cannot be placed on the seat wall)....
-
SECTION 202 DEFINITIONS
ETA Editor's Note Where ADA definitions for specific terms differ notably from CBC, the ADA definition is inserted below the CBC definition and identified by green text and headed...
-
12.2 Q. What happens if a builder deliberately manipulates the grade so that a second story, which also might have been treated as a ground floor, requires steps?
Deliberate manipulation of the height of the finished floor level to avoid the requirements of the Fair Housing Act would serve as a basis for the Department to determine that there is reasonable...
-
5b. Ramp Slope
[ADA Stds 4.7.2] Note: 1:12 is one inch of vertical height for 12 inches of horizontal distance. Yes _____ No _____...
-
Library
Offset pivot hinge on door to library Large print books in the library Handrails at two height Evaporative cooler to save the energy used by air conditioners...
-
Raised Crossings
Consult local Standards for application requirements, including slope for vehicle traffic, height, and markings....
-
B7-b
[ADA Standards § 4.7.2] Yes No Note: 1:12 is one inch of vertical height for each 12 inches of length....
-
1132A.4.1, Item 2
Thresholds with a change in height between ¼ inch (6.35 mm) and ¾ inch (19.05 mm) shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)....