Cantilevered units at standard heights for people who stand must be recessed or protected as protruding objects....
Search Results "Head Height"
Filters
Commonly Searched Documents
-
Do drinking fountains pose hazards as protruding objects?
-
U.S. Department of Transportation, Federal Transit Administration, Office of Civil Rights
Headed by an Administrator who is appointed by the President of the United States, the FTA functions through a Washington, D.C., headquarters office and ten regional offices which assist...
-
1115B.4.5, Item 5
A shower spray unit with a hose at least 60 inches (1524 mm) long that can be used both as a fixed shower head and as a hand-held shower shall be provided....
-
Accessible Routes
The accessible route must comply with ADAAG provisions for the location, width (minimum of 36 inches), passing space, head room, surface, slope (maximum of 1:12 or 8.33%), changes in level...
-
Housekeeping
Ensure the shower head is placed at its lowest level on the rod. Ensure toiletry items are placed within reach limits for those with limited reach range....
-
Section 2. Definitions
Comments on specific definitions are discussed either below or in that portion of the preamble under the particular section heading of the Guidelines in which these terms appear....
-
B. NOTIFICATION
of this Consent Decree, the County will adopt and follow the attached Notice under the Americans with Disabilities Act, Attachment A (“Notice”); distribute the Notice to all its agency heads...
-
4.20.2 Floor Space
The amount of clear floor space in front of a bathtub required by ADAAG (30"-48" min depth depending on the direction of travel by the length of the tub including a seat at the head of the...
-
Character Specifications
For characters with rectangular cross sections, a stroke thickness of 10% to 15% of the character height was specified (based on the uppercase "I")....
-
Doors in a Series
The height of door and gate hardware (34 to 48 inches) is specified in section 404.2.7....
-
306.3.4 Clearance Reduction
inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches (150 mm) in height...
-
306.3.4 Clearance Reduction
inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches (150 mm) in height...
-
Introduction
Footrest clearance height and depth...
-
306.3.4 Clearance Reduction
inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches (150 mm) in height...
-
306.3.4 Clearance Reduction
inches (230 mm) and 27 inches (685 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches (150 mm) in height...
-
11B-703.5.8 Character spacing
Spacing between individual characters shall be 10 percent minimum and 35 percent maximum of character height....
-
American Standard Barton Single Control Pull Out Kitchen Faucet 4145SSF
Barton’s pull-out spray head allows for effortless reach and maneuverability for all your day-to-day tasks....
-
Moen Delaney with MotionSense Spot Resist Stainless One-Handle High Arc Pulldown Kitchen Faucet
resists fingerprints and water spots for a cleaner looking kitchen equipped with the Reflex™ system for smooth operation, easy movement and secure docking of the pulldown/pullout spray head...
-
203.6 Single Occupant Structures
Single occupant structures accessed only by passageways below grade or elevated above standard curb height, including but not limited to, toll booths that are accessed only by underground...
-
4. Shower Wand
Is there an adjustable height hand-held shower wand with at least a 60" long hose provided so persons who bathe from a seated position may wash and rinse with the directional spray?...
-
2. Using the Tape Measure
Using the Tape Measure A metal tape measure is needed to measure the length, width, height, and depth of various elements....
-
502.2.1 On-street parallel parking
Curbs adjacent to such spaces must be of a height that does not interfere with the opening and closing of motor vehicle doors. Figure 502.2 Vehicle Parking Spaces...
-
Food and Beverage Service
Accommodating Diners with Disabilities factsheet provides both legal standards and promising practices for paths of travel, approach to dining spaces, seating, dining table and service counter heights...
-
[A] PUBLIC WAY
of land open to the outside air leading to a street, that has been deeded, dedicated or otherwise permanently appropriated to the public for public use and which has a clear width and height...
