In addition to the arrangements and terms specific to your function (the dates, type of space used, number of expected attendees, number of sleeping rooms etc.) the venue’s standard contract...
Search Results "Expected Maximum Flight Duration"
-
Recommendations for Contracts
-
11B-705.1.2.2 Curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
Running Slope [1018.7.1]
When the running slope of a segment of beach access route is steeper than 1:20 (5 percent), the maximum length of the segment is specified in table 6, and a resting interval must be provided...
-
407.8.3.2.2 Knee and Toe Space under ICT with Obstructed Forward Reach
Knee and toe space under ICT shall be 27 inches (685 mm) high minimum, 25 inches (635 mm) deep maximum, and 30 inches (760 mm) wide minimum and shall be clear of obstructions....
-
11B-705.1.2.2 Curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-703.2.7 Character spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
11B-703.2.7 Character spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
11B-705.1.1.2 Dome spacing
Truncated domes in a detectable warning surface shall have a center-to-center spacing of 2.3 inches (58 mm) minimum and 2.4 inches (61 mm) maximum, and a base-to-base spacing of 0.65 inch...
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
604.2 Location
The centerline of the water closet shall be 16 inches (405 mm) minimum to 18 inches (455 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (430...
-
703.2.7 Character Spacing
Where characters have rectangular cross sections, spacing between individual raised characters shall be 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum....
-
E. Reporting, Recordkeeping, and Other Compliance Requirements
As discussed in section V.A.3 above, the Department expects that the additional cost and burden of noting which screenings will be captioned or audio-described is de minimis when a movie...
-
2.1(a)(iii) Substantially Limits
its nature and severity; how long it will last or is expected to last; its permanent or long term impact, or expected impact....
-
Annualized Costs of New Accessibility Requirements for OTRBs
7% Discount Rate $549 $971 $1,513 As this table demonstrates, the cost of the new OTRB accessibility requirements are expected...
-
4.1.2. Upfront Costs
Overall, the upfront costs to movie theaters are expected to total $34.2 million when discounted at 7 percent....
-
Bus Shelter Benches
Don't you think that's because 903 benches are designed for wheelchair users to transfer onto them and that's not expected to be necessary at bus shelter benches? ...
-
11B-805.7 Built-in cabinets and work surfaces
Since there is no change to the wording of Section 11B-805.7, there is no reason to expect that OSHPD will change its interpretation....
-
11B-805.7 Built-in cabinets and work surfaces
Since there is no change to the wording of Section 11B-805.7, there is no reason to expect that OSHPD will change its interpretation....
-
SUMMARY OF PRELIMINARY REGULATORY ANALYSIS
On the benefits side, the Preliminary RIA estimates likely incremental benefits by monetizing the value of three categories of benefits expected to accrue from the proposed 508 Standards...
-
11B-410.6 Doors and gates
Exception: Platform lifts serving two landings maximum and having doors or gates on opposite sides shall be permitted to have self-closing manual doors or gates....
-
11B-410.6 Doors and gates
Exception: Platform lifts serving two landings maximum and having doors or gates on opposite sides shall be permitted to have self-closing manual doors or gates....
-
11B-1008.4.3 Play tables
The tops of rims, curbs, or other obstructions shall be 31 inches (787 mm) high maximum....