Base cabinets directly under sinks and work surfaces shall be removable as required in Section 1133A.3....
Search Results "Surface Material"
Filters
Commonly Searched Documents
-
1133A.4.1, Item 2
-
2004 ADA and ABA Accessibility Guidelines
The following technical criteria in the proposed standards are based on the 2004 ADA and ABA Accessibility Guidelines: • Height of transfer surfaces on diagnostic equipment used by patients...
-
2. Is this trail primarily surfaced with a material other than asphalt, concrete, or boardwalk?
Is this trail primarily surfaced with a material other than asphalt, concrete, or boardwalk? Yes No If “No” is selected, then skip to “End of Survey” (Qualtrics Option)....
-
1133A.4.1, Item 2
Base cabinets directly under the kitchen sink counter area and work surface shall be removable as required in Section 1133A.3....
-
Rebuilding Together Acadiana - Lafayette, LA
We organize volunteers and use donated or discounted building materials to complete repairs at no cost to our homeowners....
-
709.2 Materials
Smoke barriers shall be of materials permitted by the building type of construction....
-
704.4 Materials
Exterior walls shall be of materials permitted by the building type of construction....
-
Rebuilding Together Atlanta - Atlanta, GA
RTA leverages each dollar four times through donated materials and labor, providing significant renovations at no cost to the homeowner or non-profit facility....
-
M305.3.1.1 Horizontal Position
The length of gripping surfaces on horizontal standing supports shall be 4 inches (100 mm) minimum except for diagnostic equipment containing a wheelchair space which shall comply with M305.3.1.2...
-
M301.2.1 Adjustability (Section-by-Section Analysis)
The MDE NPRM proposed a transfer surface height range for diagnostic equipment used by patients in the supine, prone, or side-lying position of 17 inches minimum and 19 inches maximum....
-
Rebuilding Together Of Greater Green Bay - Green Bay, WI
We seek cost effective leveraging of donated materials, supplies and labor. Volunteer service on National Rebuilding Day is our core initiative and common denominator....
-
Rebuilding Together San Diego - San Diego, CA
Hundreds of civic-minded companies, building tradesmen and community groups support our work with sponsorships, financial contributions, and in-kind donations of both resources and materials...
-
M305.3.2.2 Vertical Position
The height of the lowest end of the gripping surface on vertical standing supports shall be 34 inches (865 mm) minimum and 37 inches (940 mm) maximum above the standing surface....
-
§ 38.23(c)(8) Handrails
them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp surface...
-
Rebuilding Together Solano County Inc. - Vallejo, CA
This is accomplished with volunteer skilled and unskilled labor, donated materials/services and financial support from within Solano County....
-
1012.5 Slope
This section requires the slope of the surface of parking spaces and pull-up spaces to not be steeper than 1:48 in any direction....
-
Passenger Loading Zones [4.6.6]
A level surface (maximum 2% slope in any direction) for both the space and aisle is important for wheelchair transfer to and from vehicles and deployment of vehicle lifts or ramps....
-
1014.3 Floor
The floor within camp shelters shall comply with 1014.3.
-
R304.5.3 Cross Slope
R304.5.3 Cross Slope. The cross slope of curb ramps, blended transitions, and turning spaces shall be 2 percent maximum. At pedestrian street crossings without yield or stop control...
-
Addendum F: Relative Height Differences
Relative heights were calculated for high and low transfers for all three protocols. Refer to Addendum A for the definition of relative height. The following tables F1-F3 represent...
-
1014.3 Floor
The floor within camp shelters shall comply with 1014.3.
-
1.1.12 Ramp cross slope
1.1.12 Ramp cross slope. Measure for overall cross slope of ramps by establishing elevations at the extreme edges of the ramp at the top and bottom of the ramp and calculate the...
-
Rockwood Manufacturing Company 702 Handrail Bracket
Specifications: Material: Cast Brass FASTENER: Wood Rail: 3 ea. #12 x 2 FH WS; 2 ea. #8 x 3/4 OH SMS Metal Rail: 3 ea. #12 x 2 FH WS; 2 ea. 8-32 x 3/4 OH SMS Ordering: Specify...
-
4.8.5* HANDRAILS
(2) If handrails are not continuous, they shall extend at least 12 in (305 mm) beyond the top and bottom of the ramp segment and shall be parallel with the floor or ground surface....
