Section 207 covers scoping requirements in the most current ADA Standards for accessible means of egress.
Search Results "Emergency Warning System"
Filters
Commonly Searched Documents
-
Accessible Means of Egress: ADA Standard Section 207
-
University of Alabama at Birmingham (UAB) ADA Professional Training Certificate Program
Emergency preparedness will also be a topic of interest in this course. ...
-
Visible Alarms in Guest Rooms with Communication Features
is upgraded or replaced, or a new fire alarm system is installed....
-
205 Operable Parts
controls) shall comply with 4.27. 4.27.3 Exception: These requirements do not apply where the use of special equipment dictates otherwise or where electrical and communications systems...
-
706.6 Peak Clipping Level
Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech. [ECTCR UFAS 4.33.7]
-
708.3 Handsets
Handset cords, if provided, shall be 29 inches (735 mm) long minimum.
-
§382.83 Through what mechanisms do carriers make seating accommodations?
[See subsections ...]
-
11B-706.6 Peak clipping level
Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech.
-
382.83 Through what mechanisms do carriers make seating accommodations?
382.83 Through what mechanisms do carriers make seating accommodations? ETA Editor's Note This section has no content in the original document.
-
11B-708.3 Handsets
Handset cords, if provided, shall be 29 inches (737 mm) long minimum.
-
708.3 Handsets
Handset cords, if provided, shall be 29 inches (735 mm) long minimum.
-
706.6 Peak Clipping Level
Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech.
-
Requirements to Remember for: Light Rail Projects
[See subsections ...]
-
706.6 Peak Clipping Level
706.6 Peak Clipping Level. Peak clipping shall not exceed 18 dB of clipping relative to the peaks of speech.
-
Sec. 12143. Paratransit as a complement to fixed route service. [Section 223]
[See subsections ...]
-
708.3 Handsets
708.3 Handsets. Handset cords, if provided, shall be 29 inches (735 mm) long minimum.
-
4.28.3(3)
(3) The maximum pulse duration shall be two-tenths of one second (0.2 sec) with a maximum duty cycle of 40 percent. The pulse duration is defined as the time interval between initial...
-
4.3.11.4* Two-way Communication
A method of two-way communication, with both visible and audible signals, shall be provided between each area of rescue assistance and the primary entry. The fire department or...
-
A4.28 Alarms
[See subsections ...]
-
Location and Spacing
Location and Spacing Rooms with an area than can be circumscribed by a circle 50 feet in radius can be covered by a single centrally located strobe of 75 cd. For very small rooms,...
-
4.28.3(5)
(5) The flash rate shall be a minimum of 1 Hz and a maximum of 3 Hz.
-
Mounting Height
Mounting Height ADAAG specifies a signal height 80 inches above the highest floor level within the space or 6 inches below the ceiling, whichever is lower. (This can be measured...
-
4.28 Alarms
[See subsections ...]
-
2.1.2.3 New York State Standards
2.1.2.3 New York State Standards Ambient electro-magnetic fields should not exceed 30 mA/meter; higher levels would preclude the installation of an IL in the particular location....