Where a clear floor or ground space is located in an alcove or otherwise confined on all or part of three sides, additional maneuvering clearance shall be provided in accordance with 305.7.1...
Search Results "Push Side"
Filters
Commonly Searched Documents
-
305.7 Maneuvering Clearance
-
4.30.6 MOUNTING LOCATION AND HEIGHT
Interior signage shall be located alongside the door on the latch side and shall be mounted at a height of between 54 in and 66 in (1370 mm and 1675 mm) above the finished floor....
-
4.34.5.2(1)
The water closet may be located with the clear area at either the right or left side of the toilet....
-
Common Problems with Signs
Problems with Signs Ø Some signs – such as permanent room signs – are required to have Braille, high contrast, and raised lettering and must be located on the wall to the latch side...
-
Bedside Clearance [9.2.2(1)]
Bedside Clearance [9.2.2(1)] Where one bed is provided in a room, maneuvering space at least 36 inches wide is required on both sides of the bed....
-
11B-608.3.2 Standard roll-in type shower compartments
Grab bars shall be provided on the back wall and the side wall opposite the seat. Grab bars shall not be provided above the seat....
-
409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall. Figure 409.4.6.2 Location of Private Residence Elevator Control Panel...
-
T215.2.4 Destination and Route Signs
Where destination or route signs are provided on the exterior of non-rail vehicles, such signs shall be located at a minimum on the front and boarding sides of the vehicle....
-
H23
Is the door to the toilet stall located diagonally opposite, not directly in front of, the toilet or on the opposite side wall from the wall with the long grab bar?...
-
4.7.9 Location at Marked Crossings
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). ...
-
4.7.9 LOCATION AT MARKED CROSSINGS
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). Figure 15 Curb Ramps at Marked Crossings...
-
§ 38.159(c)(4) Ramp barriers
Each side of the ramp shall have barriers at least 2 inches (50 mm) high to prevent mobility aid wheels from slipping off....
-
§ 38.95(c)(4) Ramp barriers
Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off....
-
§ 38.125(c)(4) Ramp barriers
Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off....
-
§ 38.83(c)(4) Ramp barriers
Each side of the ramp or bridge plate shall have barriers at least 2 inches high to prevent mobility aid wheels from slipping off....
-
Norton Surface Mounted 7100SZ Series SafeZone® Electromechanical Closer
Features: Multi-point, electromechanical closer/holder Sensor detects movement in both directions Selectable hold open time and sensitivity Push or pull side mounting Handed...
-
Brinks Home Security Alwood Keyed Entry Lever
Push Pull Rotate™ the hands-full door lock from Brinks Home Security. The only door lock that opens 3 ways. Push it, pull it, or rotate it....
-
F105.2.2 ASME
The communication system must be push button activated. The activation button must be permanently identified with the word "HELP."...
-
QUESTION: WHAT CONSIDERATIONS APPLY TO PVOs’ OBLIGATION TO PROVIDE ASSISTANCE TO PASSENGERS WITH DISABILITIES WITH RESPECT TO BOARDING AND DISEMBARKING FROM VESSELS?
., lifts, ramps, boarding chairs, assistance by PVO personnel in pushing a wheelchair or guiding a blind passenger)....
-
Problem Two (Entrance)
Solution: Short ramps or wedges may be used on both sides of the threshold to allow a voter in a wheelchair to pass over the threshold....
-
f-v
Are the controls and operating mechanisms mounted no more than 54 inches above the floor for a side reach or 48 inches for a forward reach?...
-
M21
If a coat hook is provided, is it mounted no higher than 54 inches above the floor for a side approach or 48 inches above the floor for a front approach?...
-
1133A.4.1, Item 3
The sides of adjacent cabinets and the back wall, which may become exposed to moisture or food handling when a countertop is lowered, shall be constructed of durable, nonabsorbent materials...
-
11B-409.4.6.2 Location
Control panels shall be on a side wall, 12 inches (305 mm) minimum from any adjacent wall. FIGURE 11B-409.4.6.2 LOCATION OF PRIVATE RESIDENCE ELEVATOR CONTROL PANEL...
