Swinging door and gate surfaces within 10 inches (254 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
Search Results "Measuring Technique"
Commonly Searched Documents
-
11B-404.2.10 Door and gate surfaces
-
M301.4.2 Clearance Around Base (Section-by-Section Analysis)
The proposed rule required a minimum clearance of 6 inches high measured from the floor and 36 inches deep measured from the edge of the examination surface. NPRM, 77 FR at 6927....
-
5.1.1 Transfer Surface Height Adjustability Recommendation for M301 and M302
In determining these heights, project researchers measured the seat heights from underneath the buttocks at the center of the occupied seats, a spot likely to be lower than the front of...
-
Safe harbor for qualified small businesses regarding what is readily achievable. (Section-by-Section Analysis)
Advocacy groups both for individuals with disabilities and private businesses requested specific guidance on what measures were required for barrier removal. ...
-
2.1 Participant Recruitment and Sampling
Researchers at each of these sites were trained in the data collection methods and used the same measurement equipment to ensure consistency in measurement methods across sites....
-
4.3.5.3 180-degree turn around an obstacle
Findings from the Anthropometry of Wheeled Mobility Study indicate that a uniform width of at least 89.5 cm (35 in.) was required for 50% of the manual and power wheelchair users measured...
-
Location and Size
The side rails are 20 inches minimum in length, 6 inches minimum in height above the table surface, and 1 inch measured horizontally from the adjacent edge of the table surface....
-
Section 36.301 Eligibility Criteria (Preamble, Section-by-Section Analysis)
§ 36.301 provides that public accommodations may not place a surcharge on a particular individual with a disability or any group of individuals with disabilities to cover the costs of measures...
-
2.4.2 Considerations of Manufacturers in Accessible MDE Design
MDE manufacturers believe that their usability requirements should include some measure of accessibility....
-
B. Survey, Compliance and Review of Polling Place Locations
Department concludes that the Board or the ThirdParty Expert has proposed a remedial provision that does not address the violation, then the Department will recommend a temporary remedial measure...
-
Section 36.301 Eligibility Criteria (Section-By-Section Analysis and Response to Comments)
Sec.36.301 provides that public accommodations may not place a surcharge on a particular individual with a disability or any group of individuals with disabilities to cover the costs of measures...
- AJW Architectural Products U1314 34 oz. Unidoor Square Soap Dispenser - Recessed
- AJW Architectural Products U1304 Series 56 oz. Unidoor Horizontal Liquid Soap Dispenser - Recessed
- Willoughby Industries ETW-1445-BS-HC Toilet for 45-degree Chase Wall
- Bradley Contemporary Series Recess Mounted Soap Dispenser 6437
- AJW Architectural Products US130-A Series US130-A12 12" Exposed Flange, 1.5" Diameter Security Grab Bar - Configuration A
- Whitehall Mfg. Ligature Resistant Toilet Top Supply On-Floor
- seca 684 r Digital Multifunctional Scale with Integrated RS232 Interface
-
11B-221.6 Semi-ambulant seats
i) It is located within the rear 60% of the seats provided in an auditorium; or i) It is located within the area of an auditorium in which the vertical viewing angles (as measured...
-
Dennis W. Siemsen, O.D., Low Vision Service, Department of Ophthalmology, Mayo Clinic
And we measure that by how large and bright the stimulus can be....
-
Background
Health data for people with disabilities, DATA2010, measures health at the population level (Centers for Disease Control and Prevention, 2010)....
- The UpScale Medical Exam Table
- Stable and rock solid. See for yourself!