Where stirrups are provided, they shall provide a method of supporting, positioning, and securing the patient’s legs.
Search Results "Latch Side Clearance"
-
M301.3.2 Stirrups
-
NAADAC Webinar Series: "ADA: The Next Generation" - Virtual and At-Home Training
This unique and important series of seven webinars brings together some of the country’s most experienced ADA experts and trainers, combining the “official” view with practical...
-
3) Where the standard says "Changes in level are not permitted", but no advisory follows the standard
3) Where the standard says "Changes in level are not permitted", but no advisory follows the standard, such as 404.2.4.4 floor or ground surfaces at doors: Although the Advisory...
-
Size and Clearances for Shower Compartments: ADA Standard Section 608.2
Section 608.2 covers the current ADA Standards for the size and clearances of shower compartments.
- Pilot Rock XT Series Side Accessible Picnic Table Using Aluminum
- Pilot Rock UT Series Side Accessible Picnic Table Using Aluminum
- Pilot Rock UT Series Side Accessible Picnic Table Using Recycled Plastic
-
Side guard protocol
Side guard protocol: From initial setup, two side guards adjusted 6” (15.2 cm) higher than the subject’s WMD seat were attached, and subjects were asked to perform a level height transfer...
-
Bradley Grab Bars 1 1/2" with Concealed Mounting 812 148 Side Elevation
Requires the Premium User plan or above. (Login or upgrade your account!)
-
Single-User Toilet Rooms: No Side Transfer Space
Single-User Toilet Rooms: No Side Transfer Space On single plumbing walls, lavatories can overlap water closet clear floor space although this precludes side transfers....
-
M301.3.1 Transfer Supports
Transfer surfaces required by M301.2 shall provide transfer supports and shall comply with M305.2.
-
M305.5 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided. Where the incline of the back support can be modified while in use, head and...
-
M301.3 Supports
Transfer supports, leg supports, and reclining surfaces shall comply with M301.3.
-
M301.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided and shall comply with M305.5.
-
M301.3 Supports (Section-by-Section Analysis)
This is an introductory section. An editorial change was made to this section as a result of the change in M301.3.2, described below, to replace the word “stirrups” with the term...
-
M301.3 Supports
Transfer supports, stirrups, and reclining surfaces shall comply with M301.3.
-
M301.3.3 Head and Back Support
Where the diagnostic equipment is used in a reclined position, head and back support shall be provided. Where the incline of the back support can be modified while in use, head and...
- Brewer Assist Power Procedure Table™
-
Boarding Pier Clearances: ADA Standard Section 1003.3.2
Advisory 1003.3.2 Boarding Pier Clearances. These requirements do not establish a minimum length for accessible boarding piers at boat launch ramps....
-
General: ADA Standard Section 306.1
Section 306.1 of the ADA Standards covers information in the current ADA Standards for knee and toe clearance.
- Figure 703.4.2 Location of Tactile Signs at Doors – Drawing from the U.S. Access Board
- Figure 406.6 Diagonal or Corner Type Curb Ramps – Drawing from the U.S. Access Board
- Georgia-Pacific Compact® Side-By-Side Double Roll Bathroom Tissue Dispenser 56797
-
603.2 Clearances
603.2 Clearances. Clearances shall comply with 603.2....