The dots shall be spaced ¼ inch (6.4 mm), measured center to center, in the form of an equilateral triangle with a vertex pointing up....
Search Results "Entry Point"
Commonly Searched Documents
-
11B-411.2.1.2.3 Accessibility function button
- AJW Architectural Products UG130-A Series UG130-A12 12" Exposed Flange, 1.5" Diameter Grab Bar - Configuration A
- AJW Architectural Products UG120-A Series UG120-A12 12" Exposed Flange, 1.25" Diameter Grab Bar - Configuration A
- Arctic Access - Kotzebue, AK
- Assisted Living Directory - Top Assisted Living Markets - Salinas, California Assisted Living Facilities & Senior Care
- Signaids Family Washroom Sign
- Signaids Men's Washroom Sign
- Signaids Unisex Washroom Sign
- Signaids Women's Washroom Sign
- Allegion Falcon 2090 Cross Bar Exit Device
- Schindler's Elevator PORT (Personal Occupant Requirement Terminal)
- Stanley Hardware RP9401 Door Closer
-
M303.2.3 Depth (Section-by-Section Analysis)
However, the Access Board has reorganized this provision into three separate requirements based on how the wheelchair space is entered, made an editorial change to clarify that front or rear entry...
- Signaids Men's Washroom Directional Sign
- Signaids Women's Washroom Directional Sign
- Signaids Unisex Washroom Directional Sign
-
Automatic Doors and Power Assisted Doors [4.13.12]
Low-powered doors are typically used at entries with lower levels of traffic to provide an alternative to manual doors, including revolving doors, in the same location....
-
Kitchen Counters, Walls, and Floors
Staggered stud construction to prevent noise transmission to other rooms Zero clearance kitchen entries with less than 1/4” change of elevation throughout the accessible route. ...
-
Data Analyses
Frequency tabulations were used to identify data entry errors. T-tests and correlations were used to evaluate the relationships between numerical data....
-
§ 38.77(c)
(c) At all doors on level-entry vehicles, and at each entrance accessible by lift, ramp, bridge plate or other suitable means, handrails, stanchions, passenger seats, vehicle driver seat...
-
SEAT HEIGHT MEASUREMENT DETAIL
SEAT HEIGHT MEASUREMENT DETAIL Regardless of measurement technique used, the height is measured at the highest point of the seat, inclusive of bolsters, with the foam in an uncompressed...
-
704.11.1 Parapet construction
The height of the parapet shall not be less than 30 inches (762 mm) above the point where the roof surface and the wall intersect....
-
1008.3 Transfer Systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....
-
11B-1008.3 Transfer systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....