Wheel diameter-measured vertically from the point of contact with the ground to the highest point on the wheel. Tire or wheel width....
Search Results "Vertical Dispersion"
Commonly Searched Documents
-
Station 1-Physical Characteristics
-
Best Practice Recommendations for Layout Planning
When possible, include both โhorizontalโ (side to side) and โverticalโ (front to back) aisles to improve access and flow....
-
EXECUTIVE SUMMARY
Vertical Alignment-Crest Vertical Curves The minimum length for a crest vertical curve is a function of the stopping sight distance, the algebraic difference in the upgrade and downgrade...
- Aquatic Access Pool Lift IGAT-180
- Pilot Rock FSW-26/18 Campfire Ring
- Salsbury Industries Solid Oak Executive Wood Locker Double Tier 1 Wide
- Salsbury Industries Designer Wood Locker Single Tier 1 Wide
- Salsbury Industries Solid Oak Executive Wood Locker Double Tier 3 Wide
- Allegion Falcon 1490 Series Exit Devices
- Federal Elevator Serenus LULA Elevator
- Salsbury Industries Designer Wood Locker Single Tier 3 Wide
- Salsbury Industries Solid Oak Executive Wood Locker Triple Tier 1 Wide
- Salsbury Industries Solid Oak Executive Wood Locker Triple Tier 3 Wide
-
Roughness Calculation
Using the IRI as a model, the roughness index was found by summing the vertical deviations of the surface profile for a given horizontal distance....
-
Polling places that cannot be remediated with temporary measures:
Sidewalks & Walkways: The ramp on the route to the building has a vertical drop-off on at least one side and no edge protection is provided (1991 ADA Stds 4.8.7; 2010 ADA Stds 405.9)...
-
C. Raised Porches Are Part Of the Store That Must Be Made Accessible and Located On An Accessible Route
Pursuant to Chapter 4, Section 403, accessible routes must have compliant walking surfaces, slopes no greater than 1:20 in the direction of travel and cross slopes no greater than 1:48, vertical...
-
E. What are the General Requirements for Curb Ramps in the ADA Standards for Accessible Design?
. [ยง 4.1.6(3)(a)(ii)] The rise is the vertical change measured from the low point at the base of the curb ramp to the high point at the other end where the sloped...
-
Feature 2 - Routes to the Building Entrance
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
11B-1003.2.1 Boat slips
The vertical distance is 10 feet (3050 mm) between the elevation where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level....
-
903 Benches
The proposed rule required back support to be provided that extends vertically from a point no more than 2 inches above the bench to a height of at least 18 inches above the bench and that...
-
Passenger Elevators
The Board has retained the exception permitting LULA elevators, since it offers a more economical alternative than a standard elevator and thus may help encourage inclusion of some vertical...
-
Value Contrast (slide 9)
Fixed Surfaces To show where vertical and horizontal surfaces meet is very important. To show edges is very important....
-
Conclusion
Of the participants who attempted and were successful with both two-step transfers, the 50th percentile could attain a 7 inch vertical height difference which is close to the maximum allowable...
-
Resting Intervals on Trails
No significant difference in vertical alignment between the trail tread, turning space, and resting interval is allowed where they meet....