The vertical alignment of the ORAR, turning space, and resting interval must be nominally planar (i.e., as flat as possible) so that all the wheels of a mobility device touch the ground...
Search Results "Vertical Dispersion"
-
Resting Intervals [1016.8]
-
Dune Crossings [1018.10]
The technical requirements for dune crossings do not address the vertical pickets provided in some handrail designs....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Transit Stops (R308.1) (Section-by-Section Analysis)
Boarding platforms at transit stops must be positioned to coordinate with vehicles to minimize the vertical and horizontal gaps....
-
1010.1.7 Thresholds
Raised thresholds and floor level changes greater than ¼ inch (6.4 mm) at doorways shall be beveled with a slope not greater than one unit vertical in two units horizontal (50-percent slope...
-
Harmar IL500 Sierra Incline Platform Lift
Choose it wherever a stairway lift doesn’t fit a user’s accessibility needs or a vertical platform lift isn’t appropriate for residential use. ...
-
1002.6 Transfer Devices for Use with Amusement Rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm)....
-
11B-1002.6 Transfer devices for use with amusement rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm). ...
-
Ramps
Ramps with a rise greater than six inches must have handrails and if there are vertical drop offs on the sides, there must be edge protection....
-
11B-206.3 Location
Additionally, accessible vertical interior circulation must be in the same area as stairs and escalators, not isolated in the back of the facility....
-
1002.6 Transfer Devices for Use with Amusement Rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm)....
-
When Ramps Are Required
Rise of a ramp is the amount of vertical distance the inclined or slanted surface ascends or descends....
-
Gangway Slope and Rise Exceptions
For example, where the vertical distance between where the gangway departs the landside connection and the elevation of the pier surface at the lowest water level is 4 feet, the gangway...
-
1002.6 Transfer Devices for Use with Amusement Rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm)....
-
Alterations to stairs (Section-by-Section Analysis)
The 1991 Standards only require interior and exterior stairs to be accessible when they provide access to levels that are not connected by an elevator, ramp, or other accessible means of vertical...
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters or Other Mobility Aids
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Non-Tactile Signage
/dark contrast · non-glare finish · light/dark contrast · non-glare finish Location · 60" height to centerline on wall at latch side of doors · 80" min. vertical...
-
Car Controls [4.10.12]
the elevator code; where they are provided, they must be grouped at the bottom of the panel no lower than 35 inches from the floor Recommendation: consider a minimum 3/16 inch vertical...
-
Data acquisition
The vertical z-axis was chosen because it is parallel to the spine and lower legs of the subject, both of which are high-risk areas for negative health outcomes....
-
1.1.17 Stairs
Measure stair riser height as the vertical dimension between tread nosings....
-
Alterations to stairs. (Section-by-Section Analysis)
The 1991 Standards only require interior and exterior stairs to be accessible when they provide access to levels that are not connected by an elevator, ramp, or other accessible means of vertical...
-
11B-1002.6 Transfer devices for use with amusement rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm)....
-
11B-206.3 Location
Additionally, accessible vertical interior circulation must be in the same area as stairs and escalators, not isolated in the back of the facility. ...
-
11B-1002.6 Transfer devices for use with amusement rides
Where a series of transfers are required to reach the amusement ride seat, each vertical transfer should not exceed 8 inches (205 mm). ◼...
