Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
Search Results "Tape Measure"
-
11B-703.2.7 Character spacing
-
1133A.2.1 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, countertop or the face of any appliance (excluding handles and controls) that projects into the kitchen and the opposing...
-
11B-809.9.2 Clear width
Kitchens shall have a minimum clear width measured between any cabinet, work surface or the face of any appliance (excluding handles and controls) and the opposing cabinet, work surface,...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
604.3.2 Overlap
complying with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1675 mm) minimum measured...
-
505.4 Height
A maximum height of 28 inches (710 mm) measured to the top of the gripping surface from the ramp surface or stair nosing is recommended for handrails designed for children....
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
Section 1630.2(j)(1)(v) Scientific, Medical, or Statistical Analysis Not Required, But Permissible When Appropriate
clinically diagnosed based in part on a disparity between an individual's aptitude and that individual's actual versus expected achievement, taking into account the person's chronological age, measured...
-
5.8.2.5 Toe Height Recommendation
5.8.2.5 Toe Height Recommendation The Committee recommends increasing the toe height to 18 inches minimum, measured above the ground when the top of the breast platform is 34 inches above...
-
Acceptable Trail Surfacing Requirements
These three criteria have not been defined adequately within the ADA Accessibility Guidelines for quantitative measurement on any specific surface....
-
Step 3: Apply the Accessibility Provisions
If the grade requirement can't be met because of a condition for an exception, measure and record the length of trail that will deviate from the technical requirement....
-
2.2.2.2 New York State Standards
Measurements shall be made in the center of the neckloop....
-
3.3.4 Clear Floor Length
The difference between the maximum length in the UDI and Seeger studies and the others is so great that they are probably due to the presence of unusually large people and/or devices, or measurement...
-
Station 3-Turning Radii
The extent of the lean, as measured from the perpendicular, is the lean angle....
-
4.3.5.1 90-Degree Turn
Findings from the Anthropometry of Wheeled Mobility Study indicate that a width of at least 85 cm (33 in.) was required for 50% of the manual and power wheelchair users measured in this...
-
Examination Tables
Treatment tables typically have a fixed height of 31 inches measured from the floor to the top of the table. The lower cost products have an open base with an H-brace or shelf....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
M303.2.3 Wheelchair Spaces / Depth of Wheelchair Spaces for front or Rear Entry
(Figure 1 –Clear Platform showing the measurements of 32” wide x 40” inches length Rationale: Clear platform size of 32 inchesminimum width x 40 inches minimum length accommodates non-powered...
-
Observations and Results
Accessibility Measures During the 10-month period of the test, firmness and stability of the SEWF surfaces were measured with the rotational penetrometer (Figs. 12 and 13, respectively...
-
ASTM
ASTM F 1292 establishes a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and around playground equipment...
-
ASTM
ASTM F 1292 establishes a uniform means to measure and compare characteristics of surfacing materials to determine whether materials provide a safe surface under and around playground equipment...
-
AJW Architectural Products U155 24 oz. Vertical Liquid Soap Dispenser - Surface Mounted
Dispenses pre-measured amounts of soap to prevent waste. Valve will dispense most liquids and lotions....
