For horizontal standing supports, the Access Board proposed a gripping surface of 4 inches long minimum, the top of which would be required to be located 34 inches minimum and 38 inches...
Search Results "Recreational Surfacing"
Filters
Commonly Searched Documents
-
2. Standing Supports
-
How to Measure Transfer Surface Height
How to Measure Transfer Surface Height Regardless of the final decision on the low height measurement, the Subcommittee agreed that the height of the transfer surface would be measured...
-
Clearances Around Gripping Surfaces
Guidelines specify the following clearances around grab bars to ensure sufficient space for a person to grasp the grab bar: 1½ inches absolute clearance between grab bars and the adjacent wall surfaces...
-
M-D Building Products, Inc. GEN3 SmartTool™ Digital Level
Water and DustProof IP65 Certified Hose off after concrete or muddy jobs Dustproof for the dirtiest environment Back Light Horizontal vial...
-
Stabila, Inc. Tech Digital Electronic Level Type 196-2
Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Removable shock-absorbing end caps with anti-slip wall...
-
Stabila, Inc. Magnetic Tech Digital Electronic Level Type 96M-2
Electronic measuring technology / Two digital displays / Audible inclination guide / IP 65 Dust and Waterproof / Rare earth magnets for hands free use / Removable shock-absorbing end...
-
(2) Transfer Surface Location for Diagnostic Equipment Used in the Seated Position
Transfer onto these types of diagnostic equipment must be made from either long side, similar to the side transfer surface described above....
-
§ 38.125(b)(6) Platform surface
(6) Platform surface. The lift platform surface shall be free of any protrusions over 1/4 inch high and shall be slip resistant....
-
Check-Out Aisles [7.3]
Writing surfaces must be 36 inches maximum from the floor....
-
UltraPlay Getting Started Installation Video
Learn how to get started and prepare for the installation of your UltraPlay playground structure with this first of several installation videos.
-
Camping and Picnic Facilities and Viewing Areas on Trails [F247.4]
When camping and picnic facilities or viewing areas are constructed or altered along a trail, they must comply with the applicable scoping and technical requirements for the...
-
Width of Spaces [1012.2]
Parking spaces and pull-up spaces for RVs must be at least 20 feet wide to accommodate RVs equipped with a lift (figure 27). RVs are typically 8 feet wide and require a 9-foot-wide...
-
2.6 Passing Spaces
ORARs with a clear width less than 60 inches (1525 mm) shall provide passing spaces complying with 2.6 at intervals of 200 feet (61 m) maximum. Passing spaces and resting...
-
Poured in Place Rubber
The surface cost for PIP ranged from $6.59/sq. ft. to $19.80/sq. ft. ...
-
1012.1 General
Parking spaces within camping units and picnic units with mobility features and pull-up spaces for recreational vehicles at dump stations shall comply with 1012....
-
1012.1 General
Parking spaces within camping units and picnic units with mobility features and pull-up spaces for recreational vehicles at dump stations shall comply with 1012....
-
The Brewer Company, LLC
Company, LLC Minority Report The Brewer Company, LLC 01-Oct-2013 Final Report Medical Diagnostic Equipment Accessibility Standards Advisory Committee Section 5.1.3 Transfer Surface...
-
M305.2.5 Surface Hazards (Section-by-Section Analysis)
No public comments were submitted on this issue, but the MDE Advisory Committee voiced concern about surface hazards stating, “gripping surface configurations must provide an effective and...
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
405.3 Cross Slope
Cross slope is the slope of the surface perpendicular to the direction of travel. Cross slope is measured the same way as slope is measured (i.e., the rise over the run)....
-
5.1.1 Transfer Surface Height Adjustability
5.1.1 Transfer Surface Height Adjustability. The transfer surface should have an adjustable height in small virtually continuous increments....
-
Emu STAR ADA #303 Table
Outdoor/Indoor Table E-coated powder coat finish ADA Compliant Top Thicknewss 1 3/8" Top: Solid Steel Base: Tubular Steel Legs Assembly required: Yes
-
Pilot Rock APTX Snow Load/Extreme Load Full Size Pedestal Utility Table
Model APTX Full Sized Pedestal Rectangular Utility Tables provide a secure, permanent location which prevents theft. Tables using V-Type expanded steel and H-Type perforated...
-
Pilot Rock ART Series End Accessible Recycled Plastic Picnic Table With Arched Frame
Series Overview Model ART Picnic Tables use a contemporary design for a lighter look. The table uses three step-over frames for support so no additional steel braces are...
