Where fewer than one parking space is provided for each residential dwelling unit, parking spaces complying with Section 11B-502 shall be provided in accordance with Table 11B-208.2....
Search Results "Built-In Table"
Filters
Commonly Searched Documents
-
11B-208.2.3.1 Parking for residents
-
11B-407.4.7.2 Keypads
The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 11B-703.3.1....
-
Garaventa Artira Inclined Platform Wheelchair Lift
In restaurants, for example, the dedicated space required for a vertical platform lift can instead be used for an additional table....
-
Landscape Forms Inc. Multiplicity Bench Collection
The bench is a perfect companion to the MultipliCITY table under which it efficiently slides....
-
Safe Harbor
There is an exception for existing pools, wading pools, and spas built before March 15, 2012 [See § 36.304(g)(5)] Note: Noncomplying newly constructed and altered elements may also be...
-
Safe Harbors
There is an exception for existing pools, wading pools, and spas built before March 15, 2012....
-
3. Exception to Ramp Running Slope
The Committee reviewed and discussed the provisions on slopes for ramps as they apply to architectural elements in the built environment....
-
Customer Premises Equipment (Section-by-Section Analysis)
The guidelines do not differentiate between hardware, firmware or software implementations of a product's functions or features, nor do they differentiate between functions and features built...
-
Introduction
Tasks that are performed on the table, like rolling over, need to be accommodated....
-
4.3.5.3 180-degree turn around an obstacle
The bold dashed line in the table and figure indicates the current ADA requirements, which vary based on the passage width and space available at the base of the turn....
-
Door King Inc. 1520/1524 Stand Alone Card Readers
The 1520 is available with a built-in proximity card reader (DK Prox, AWID or HID) or can be ordered as a single door controller allowing the user to add their own 26-bit access control...
-
11B-221.2.1.3 Other boxes
In boxes other than those required to comply with Section 11B-221.2.1.2, the total number of wheelchair spaces required shall be determined in accordance with Table 11B-221.2.1.1....
-
Evaluation of transfers
Our results also showed that in terms of minimum space required for the transfer, the guidelines are insufficient (Table 12)....
-
Baseline
The cost estimates prepared by the Volpe Center are summarized in the table below, along with questions in the preamble to the proposed guidelines that seek additional information to refine...
-
11B-407.4.7.2 Keypads
The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 11B-703.3.1 _|Braille Dimensions|_....
-
1.9.1.8 Adopting agency identification
The provision of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
-
Inexpensive steps businesses might take to improve access may include:
Rearranging tables, chairs, vending machines, display racks, and other furniture to allow for easy passage throughout the business. Installing grab bars in a toilet stall....
-
WMD POSITIONS FOR TRANSFER
The lower wheelchair illustrates a typical diagonal transfer.30 Figure 11: Corner radii of a medical examination table NOTES 30....
-
§ 36.308(c)(1) Seating areas
number of wheelchair seating spaces and companion seating provided in specialty seating areas shall be included in, rather than in addition to, wheelchair space requirements set forth in Table...
-
Dining Areas [5.4]/ Raised Platforms [5.7]
Platform lifts can be used at raised platforms that serve a head table or speaker's lectern but not other dining areas except where existing constraints make ramp (or elevator) access infeasible...
-
3.1.1 Vehicle Parking
Table 3.1.1....
-
1.9.1.8 Adopting agency identification
The provision of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
-
11B-407.4.7.2 Keypads
The dot shall be 0.118 inch (3 mm) to 0.120 inch (3.05 mm) base diameter and in other aspects comply with Table 11B-703.3.1 _|Braille Dimensions|_....
-
1.9.1.8 Adopting agency identification
The provisions of this code applicable to buildings identified in this Subsection 1.9.1 will be identified in the Matrix Adoption Tables under the acronym DSA-AC....
