attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
Search Results "Slope Meter"
Commonly Searched Documents
-
Fishing piers and platforms. (Section-by-Section Analysis)
-
Fishing piers and platforms. (Section-by-Section Analysis)
attached to land) are involved, a number of exceptions are provided from the general standards for accessible routes in order to take into account the difficulty of meeting accessibility slope...
-
Location
The slope along the accessible route should not be greater than 1:12 in the direction of travel....
-
Technical Infeasibility
plumbing, life safety or other codes (such as when combining two toilet stalls to create an accessible stall would violate the plumbing code’s required fixture count); meeting slope...
-
Location
The slope along the accessible route should not be greater than 1:12 in the direction of travel....
-
11B-505.6 Gripping surface
Exceptions: Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along...
- Allegion Falcon 2390 Series Recessed Exit Device
-
Clear Floor or Ground Space
ground space is also sometimes called "wheelchair parking space." 30-inch (760 mm) by 48-inch (1220 mm) minimum area May overlap accessible routes and maneuvering spaces Slope...
-
A. The Substantive Legal Dispute
numerous deficiencies, including: (1) unsafe, non-compliant, or missing ramps; (2) broken pedestrian rights of way that are cracked, crumbled, steep, sunken, or uneven or that have improper slopes...
-
505.6 Gripping Surface
Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length...
-
Parking
Accessible parking spaces (including access aisles) must be level (maximum slope 1:48 in all directions) and each access aisle must adjoin an accessible route. ...
-
Scoping [4.1.2(1), 4.1.3(1)] and Location [4.3.2]
Clear width, surface texture, running and cross slope, and the treatment of changes in level help determine the usability of walking surfaces by people with mobility impairments....
-
Purpose of the project
For instance, when this project began, tolerances for the measurement of the slope, flatness, and smoothness of exterior walking and rolling surfaces in concrete, asphalt, unit masonry,...
-
11B-505.6 Gripping surface
Where handrails are provided along walking surfaces with slopes not steeper than 1:20, the bottoms of handrail gripping surfaces shall be permitted to be obstructed along their entire length...
-
Impact Annenuation [sic]
A 4.5 kg (10 lb.) hemispherical impact head is shown installed over the D surface at a height of 3 meters (10 feet)....
-
Conclusions
At a minimum, a 3 x 3 meter (10 x 10 ft.) surface should be installed on a working playground being accessed regularly by children....
-
11B-809.8 Doors
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25 mm), provided a ramp with a maximum slope of 1:8 is permanently installed as illustrated...
- ROXIMITY's Model O iBeacon
- ROXIMITY's Model X iBeacon
- Sloan WETS 2050.1001-1.28 Manual HET Flushometer and HET Wall Hung Water Closet
-
3. New Construction vs. Alterations
curb ramps installed must meet the accessibility requirements of the ADA to the maximum extent feasible.10 Scoping requirements in the ADA Standards establish limitations for the running slope...
-
1118B.3
Changes in level between 1/4 inch (6.4 mm) and 1/2 inch (12.7 mm) shall be beveled with a slope no greater than one unit vertical in 2 units horizontal (50-percent slope) [see Figure 11B...
-
T402 Ramps and Bridgeplates
and bridgeplates in the 2016 Non-Rail Vehicle Guidelines include provisions on design load, installation and operation, emergency operation, surfaces, clear width, edge guards, running slope...