C206.1 General (Section-by-Section Analysis) This section proposes to require that where support documentation or services are provided, they must conform to the proposed provisions of...
Search Results "Horizontal Standing Support"
Filters
Commonly Searched Documents
-
C206.1 General (Section-by-Section Analysis)
-
Usable
access to the full functionality and documentation for the product, including instructions, product information (including accessible feature information), documentation, and technical support...
-
11B-602.5 Spout location
The spout shall be located 15 inches (381 mm) minimum from the vertical support and 5 inches (127 mm) maximum from the front edge of the unit, including bumpers....
-
11B-708.4.2 Residential dwelling unit interface
The residential dwelling unit system interface shall include a telephone jack capable of supporting voice and TTY communication with the common use or public use system interface....
-
902 Dining Surfaces and Work Surfaces
commenters considered the term too limiting and questioned whether it would apply, as they felt it should, to surfaces used for purposes not necessarily considered "work," such as counters that support...
-
Telescopes and Periscopes
Whenever a telescope or periscope is provided, ensure that a separate telescope or periscope is available for use from a standing position (60 inches above the floor or ground surface is...
-
411.1.1 Decoding of Closed Captions (Section-by-Section Analysis)
Captions (Section-by-Section Analysis) This section proposes that, where audio-visual players and displays process video with synchronized audio, they must decode closed caption data and support...
-
§100.500(b)(2)
(2) A legally sufficient justification must be supported by evidence and may not be hypothetical or speculative....
-
Comments
Disability community commenters unanimously supported the Department's proposal....
-
M302.1 General
Diagnostic equipment that supports patients in a seated position shall comply with M302. ...
-
§ 1194.2(a)(2)
(2) When procuring a product, if an agency determines that compliance with any provision of this part imposes an undue burden, the documentation by the agency supporting the procurement...
-
4.26.3(3)
Shear force induced in a fastener or mounting device from the application of 250 lbf (1112N) shall be less than the allowable lateral load of either the fastener or mounting device or the supporting...
-
Need for This Technical Assistance
investigation arose from a complaint that a mother with a developmental disability was subject to discrimination on the basis of her disability because the State did not provide her with supports...
-
Spaces and Elements: ADA Standard Section 206.2.4
Section 206.2.4 covers the scoping requirements in the most current ADA Standards for accessible routes connecting spaces and elements within a building.
-
Press Boxes: ADA Standard Section 206.2.7
Section 206.2.7 covers scoping requirements in the most current ADA Standards for accessible routes to press boxes.
-
11B-206.2.7 Press boxes
An accessible route shall not be required to free-standing press boxes that are elevated above grade 12 feet (3660 mm) minimum provided that the aggregate area of all press boxes is 500...
-
Switching Between Voice and TTY Modes
Call takers who use stand-alone TTYs can switch from TTY mode back to voice mode simply by removing the telephone handset from the TTY couplers....
-
Common Problems with Signs
When signs are mounted directly on doors that open out, people who are blind or who have low vision must stand in the swing of the door to read the signs, causing a potential for injury....
-
307.3 Post-Mounted Objects
Free-standing objects mounted on posts or pylons shall overhang circulation paths 12 inches (305 mm) maximum when located 27 inches (685 mm) minimum and 80 inches (2030 mm) maximum above...
-
Kick Scooters
Kick Scooters This group includes users of kick scooters that typically have two inline wheels connected by a platform that is large enough for a user to stand on with one or two feet...
-
410.6 Real-Time Text Functionality (Section-by-Section Analysis)
Proposed 410.6 would require that, where ICT supports real-time voice communication, it must also support RTT functionality....
-
11B-703.3.2 Position
Braille shall be positioned below the corresponding text in a horizontal format, flush left or centered. If text is multi-lined, Braille shall be placed below the entire text....
-
Side guard protocol
Then from initial setup, the horizontal distance between the wheelchair and platform was incrementally increased and the maximum attainable gap distance was recorded....
-
1132A.4.1 Thresholds
Thresholds with a change in height between ¼ inch (6.35 mm) and 3/4 inch (19.05 mm) shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)...