carrier, you must negotiate in good faith with the airport operator of each U.S. airport described in §382.95(b) to ensure the provision of lifts for boarding and deplaning where level-entry...
Search Results "Sloped Entry"
-
§382.99(a)
-
§ 37.42(d)
(d) Before constructing or altering a platform at a station covered by paragraph (c) of this section, at which a railroad proposes to use a means other than level-entry boarding, the railroad...
-
§ 37.42(d)
(d) Before constructing or altering a platform at a station covered by paragraph (c) of this section, at which a railroad proposes to use a means other than level-entry boarding, the railroad...
-
NPRM
The NPRM would have required that railroads use level-entry boarding as the preferred means of ensuring nondiscriminatory access....
-
Vertical Dispersion: ADA Standard Section 221.2.3.2
Section 221.2.3.2 covers scoping requirements in the current ADA Standards for vertical dispersion in assembly areas.
-
Transition Plates
Transition Plates Transition plates are sloping pedestrian walking surfaces located at the end of a gangway....
-
Maneuvering Space Where Ramps are Provided
The space must have a slope no steeper than 1:48 in all directions. ...
-
Transition Plates
Transition Plates Transition plates are sloping pedestrian walking surfaces located at the end of a gangway....
-
Are screen doors or storm doors considered “doors in series”?
No, screen or storm doors are not considered “doors in series” since they are part of the same doorway opening as the entry door....
-
505.1 General
Handrails are not required on walking surfaces with running slopes less than 1:20....
-
704.11.1 Parapet construction
Where the roof slopes toward a parapet at a slope greater than two units vertical in 12 units horizontal (16.7-percent slope), the parapet shall extend to the same height as any portion...
-
11B-505.1 General
Handrails are not required on walking surfaces with running slopes less than 1:20....
-
505.1 General
Handrails are not required on walking surfaces with running slopes less than 1:20....
-
Attachment I: Program Access in Existing Facilities
Attachment I: Program Access in Existing Facilities
-
1131A.2 Changes greater than ½ inch
Changes in level greater than ½ inch (12.7 mm) shall be made by means of a sloped surface not greater than 1 unit vertical in 20 units horizontal (5-percent slope), or a ramp, elevator or...
-
1131A.1 Changes in level not exceeding ½ inch
When changes in level do occur, they shall be beveled with a slope no greater than 1 unit vertical in 2 units horizontal (50-percent slope)....
-
1018.1 General
The technical requirements address connections (1018.2); surface (1018.3); clear width (1018.4); obstacles (1018.5); openings (1018.6); slopes, including running slope (1018.7.1) and cross...
-
Catch Pools
An accessible means of entry or exit is not required into the catch pool. However, an accessible route must connect to the edge of the catch pool....
-
2.3 Restrooms
Is the entry door at least 32 inches wide?...
-
1018.2 Connections
This section requires beach access routes to connect an entry point to the beach to the high tide level at tidal beaches; mean high water level at river beaches; and normal recreation water...
-
Rise
The maximum length of a run is determined by the rise (30 inches maximum) and the slope: Max. Rise Slope Max. Length Max. Rise Slope Max....
-
505.1 General
Handrails are not required on walking surfaces with running slopes less than 1:20....
-
Beveled: ADA Standard Section 303.3
Section 303.3 covers the current ADA Standards for beveled level changes.
-
1017.10 Trailhead Signs
requires trail information signs at trailheads to include information on the length of the trail or trail segment; surface type; typical and minimum tread width; typical and maximum running slope...