Seats shall be 2 inches (51 mm) high maximum. [2010 ADA Standards] 604.4 Seats....
Search Results "High Speed Rail"
-
11B-604.4 Seats
-
11B-604.4 Seats
Seats shall be 2 inches (51 mm) high maximum. [2010 ADA Standards] 604.4 Seats....
-
Horizontal Alignment
However, given that their 85th percentile speed is 8 km/h (5 mi/h), the minimum radius required for manual wheelchair users would be 12.2 m (40 ft)....
-
Electric Bicycles
"(15) Because many State statutes limit speeds to 32 km/h (20 mi/h), manufacturers generally design and govern their electric bicycles to match this speed....
-
11B-809.8.1 Door Thresholds
Secondary exterior door thresholds, including sliding door tracks, shall be 3/4 inch (19.1 mm) high maximum with a 1:2 maximum slope....
-
11B-1005.4 Clear floor or ground space
At each location where there are railings, guards, or handrails complying with Section 11B-1005.2.1, a clear floor or ground space complying with Section 11B-305 shall be provided....
-
T603.2 Orientation
Wheelchair securement systems shall secure the wheelchair so that the occupant faces the front of the non-rail vehicle....
-
T404.3 Ramps and Bridgeplates
Where the space between the floor of non-rail vehicles and a boarding platform is greater than 2 inches (51 mm) horizontally or 5/8 inch (16 mm) vertically when measured at 50 percent passenger...
-
§ 37.81(a)
(a) Except as provided elsewhere in this section, each public entity operating a rapid or light rail system which, after August 25, 1990, purchases or leases a used rapid or light rail vehicle...
-
11B-1005.4 Clear floor or ground space
At each location where there are railings, guards, or handrails complying with Section 11B-1005.2.1, a clear floor or ground space complying with Section 11B-305 shall be provided....
-
11B-1005.4 Clear floor or ground space
At each location where there are railings, guards, or handrails complying with Section 11B-1005.2.1, a clear floor or ground space complying with Section 11B-305 shall be provided....
- Magnuson Group DACAPO Brochure & Leaflet Holders
-
1.6.5 Designated Public Transportation.
Transportation provided by a public entity (other than public school transportation) by bus, rail, or other conveyances (other than transportation by aircraft or intercity or commuter rail...
-
12182(b)(2)(A)(iv)
(iv) a failure to remove architectural barriers, and communication barriers that are structural in nature, in existing facilities, and transportation barriers in existing vehicles and rail...
-
Typical Day - Advanced Training
This session covers everything from the tradeoff between speed and thoroughness to the use of photographs, field computers, checklists and tricks for surveying accurately at high speed....
-
"Auxiliary Aids and Services" (Section-by-Section Analysis)
notes is inappropriate for lengthy or complicated communications, it can be appropriate for situations such as routine requests for written information, for a police officer issuing a speeding...
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
Section 37.35 Supplemental Service for Other Transportation Modes
Another instance is one in which a commuter rail operator uses fixed route bus service as a dedicated connection to, or extension of, its rail service....
-
Recumbent Bicycles
This typically results in slower acceleration from stops and the need for lower gears on hills, resulting in slower climbing speeds....
-
Section 37.59 Differences in Accessibility Completion Date Requirements
., there is no need to install an elevator, and platform accessibility can be achieved by use of a relatively inexpensive mini-high platform)....
-
R305.1.4 Size
At pedestrian at-grade rail crossings not located within a street or highway, detectable warnings shall extend the full width of the crossing....
-
Examination Tables
Power tables have an electric motor that can adjust the table height to as low as 18 inches and as high as 40 inches above the floor on some products....
-
11B-904.4.2 Forward approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum shall be provided....
-
11B-904.4.2 Forward approach
A portion of the counter surface that is 36 inches (914 mm) long minimum and 34 inches (864 mm) high maximum shall be provided....