Accessibility - Flatness and Lippage: With regard to flatness, the amount of substrate variation generally is reflected in the finished tile installation....
Search Results "Finished Grade"
Filters
Commonly Searched Documents
-
Accessibility - Flatness and Lippage
-
Allegion Falcon SC90 Series Surface Mounted Door Control
Specifications Meets ANSI A117.1 ANSI/BHMA A156.4, Grade 3 UL Listed Closer mounts hinge side, top jamb or parallel arm when either the Rw/PA or Hw/PA arm...
-
Sargent 1331 Series Aluminum Door Closer
The SARGENT 1331 Series door closer can be used for the most common applications and is a Grade 1 fully adjustable closer....
-
Stanley Hardware RP9401 Door Closer
and doors between the house and garage Designed for use on out swinging or in swinging wood or metal doors up to 1-3/8" thick Hold open feature Fully adjustable closing speeds Grade...
-
SDC S6000 Spectra Exit Devices
The new SDC S6000 Spectra™ series panic and fire rated exit devices are available in rim mount, mortise and vertical rod configurations and are UL listed and ANSI A156.3 Grade 1 compliant...
-
Eliason Corporation SCP-8 High Pressure Laminate Traffic Door
They are constructed of 7-ply exterior grade plywood clad on both sides with High Pressure Laminate available in a virtually limitless selection of colors and patterns....
-
Contrast and wayfinding, short-term and long-term
So along with stair safety goes finishes, just paint the stupid things. Fifty cents a square foot....
-
Toilet Paper Dispensers
inches maximum in front of the water closet measured to the centerline of the dispenser.The paper outlet of the dispenser must be located 15 inches minimum and 48 inches maximum above the finish...
-
1136A.1 Receptacle heights
more than 48 inches (1219 mm) measured from the top of the receptacle outlet box nor less than 15 inches (381 mm) measured from the bottom of the receptacle outlet box to the level of the finished...
-
3. MINIMUMS, MAXIMUMS AND SPECIFYING AT THE LIMIT
construction, notes and dimensions in construction documents should identify and incorporate expected tolerances so that a required dimensional range is not exceeded by the addition of a finish...
-
5.1 Transfer Surface Height Recommendations
5.1 Transfer Surface Height Recommendations Description: The transfer height is set above the finished floor surface to permit transfers form mobility devices onto the transfer surface...
-
203.9 Employee Work Areas
Employee work areas, or portions of employee work areas, other than raised courtroom stations, that are less than 300 square feet (28 m2) and elevated 7 inches (180 mm) or more above the finish...
-
2. b. ii. Accessible Door Hardware
Hardware required for accessible door passage shall be mounted no higher than 48 in (1220 mm) above finished floor. xv Figure 14 and 15 (top and bottom left) Non-accessible door...
-
1136A.1 Receptacle heights
more than 48 inches (1219 mm) measured from the top of the receptacle outlet box nor less than 15 inches (381 mm) measured from the bottom of the receptacle outlet box to the level of the finished...
-
Mary Ann Hay, IALD, LEED™ AP. Artificial Lighting
This is a completely below-grade executive conference center....
-
11B-403.3 Slope
Exception: The running slope of sidewalks shall not exceed the general grade established for the adjacent street or highway. Advisory 11B-403.3 Slope. ...
-
R208 Detectable Warning Surfaces (Section-by-Section Analysis)
locations on pedestrian access routes and at transit stops: Curb ramps and blended transitions at pedestrian street crossings; Pedestrian refuge islands; Pedestrian at-grade...
-
R204 Pedestrian Access Routes (Section-by-Section Analysis)
Pedestrian access routes must be provided within: Sidewalks and other pedestrian circulation paths located in the public right-of-way; Pedestrian street crossings and at-grade...
-
D. Examples of Schools to Which These Guidelines Apply
A junior high school, middle school, or those grades of a comprehensive high school that offers instruction to inform, orient, or prepare students for vocational education at the secondary...
-
11B-403.3 Slope
Exception: The running slope of sidewalks shall not exceed the general grade established for the adjacent street or highway. Advisory 11B-403.3 Slope....
-
Seton Directional Entrance Sign - Left Arrow
Use Accessible Entrance Signs to direct users to the nearest accessible entrance Engineer Grade reflective .063" aluminum material is equally visible day or night Extend the life...
-
Sargent 8200 Lever Lock
The 8200 far surpasses ANSI/BHMA A156.13 Series 1000 Grade 1 standards, making it the strongest and most durable mortise lock in the industry....
-
Deltrex J109 Jumbo Push Plate Switch
A full list of customizable options are available Features Steel box powder coated Push plate is 1/4" thick marine grade aluminum Tested for 1,000,000 cycles Furnished with...
-
11B-203.9 Employee workstations
Employee work areas, or portions of employee work areas, other than raised courtroom stations, that are less than 300 square feet (28 m2) and elevated 7 inches (180 mm) or more above the finish...
