Where needed and to the extent required by law, you must provide services personnel, wheelchairs, and ramps or mechanical lifts....
Search Results "Exit Ramp"
Commonly Searched Documents
-
C. Air Travelers with a Disability Changing Planes
-
M303.3.3.4 Edge Protection
Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side with a drop off....
-
Accessible Route Into and Through the Business
Ensure that accessible exits - including accessible emergency exits - are maintained at all times....
-
General Accommodations
General Accommodations: Employers should have emergency alarms and signs showing the emergency exit routes....
-
What if a locality is not resurfacing an entire block, but is resurfacing a crosswalk by itself?
Regardless of whether there is curb-to-curb resurfacing of the street or roadway in general, resurfacing of a crosswalk also requires the provision of curb ramps at that crosswalk....
-
Question 1
Are all accessible parking spaces, access aisles, curb ramps, and connecting accessible routes clear of obstacles including vehicles without proper designation, shopping carts, gravel, snow...
-
11B-216.2 Designations
Tactile exit signs complying with Chapter 10 contribute to a safe environment for people with visual impairments. ◼...
- GameTime Apollo Playground Equipment
-
F209.2.2 Bus Loading Zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
209.2.2 Bus Loading Zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
- Kompan, Inc. M512 - Sand Pit
-
11B-209.2.2 Bus loading zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
209.2.2 Bus Loading Zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
11B-209.2.2 Bus loading zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
§ 38.83(c)(8) Handrails
grasp them from outside the vehicle while starting to board, and to continue to use them throughout the boarding process, and shall have the top between 30 inches and 38 inches above the ramp...
-
11B-209.2.2 Bus loading zones
In bus loading zones restricted to use by designated or specified public transportation vehicles, each bus bay, bus stop, or other area designated for lift or ramp deployment shall comply...
-
E. Chapter 4: Boarding and Alighting
Chapter 4 in the 2016 Non-Rail Vehicle Guidelines, which sets forth the technical requirements for ramps and bridgeplates, accessible means of level boarding and alighting, lifts, and steps...
-
Q5: Effective Date for Public Entities to Comply
The obligation to provide curb ramps when roads are altered has been an ongoing obligation under the regulations implementing title II of the ADA (28 CFR 35.151) since the regulation was...
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”. [2010...
-
Common Problems with Signs
Common Problems with Signs Ø Some signs – such as permanent room signs – are required to have Braille, high contrast, and raised lettering and must be located on the wall to...
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces. Spacing between individual characters shall be 10 percent minimum...
-
703.5.4 Character Proportions
Characters shall be selected from fonts where the width of the uppercase letter "O" is 55 percent minimum and 110 percent maximum of the height of the uppercase letter "I".
-
703.5.4 Character Proportions
Characters shall be selected from fonts where the width of the uppercase letter "O" is 55 percent minimum and 110 percent maximum of the height of the uppercase letter "I".
-
703.5.8 Character Spacing
Character spacing shall be measured between the two closest points of adjacent characters, excluding word spaces. Spacing between individual characters shall be 10 percent minimum...