Stroke thickness of the uppercase letter “I” shall be 10 percent minimum and 20 percent maximum of the height of the character. [2010 ADA Standards] 703.5.7 Stroke Thickness....
Search Results "Exit Ramp"
Filters
Commonly Searched Documents
-
11B-703.5.7 Stroke thickness
-
11B-703.4 Installation height and location
Signs with tactile characters shall comply with Section 11B-703.4.
-
Designing Sidewalks and Trails for Access, Part II of II: Best Practices Design Guide
This guidebook is the second part of a two-phase project focused on designing sidewalks and trails for access. It was created to provide planners, designers, and transportation...
-
Designing Sidewalks and Trails for Access, Part I of II: Review of Existing Guidelines and Practices
Sidewalks and trails serve as critical links in the transportation network by providing pedestrian access to commercial districts, schools, businesses, government offices, and...
-
seca 664 - electronic wheelchair scale_without comments - seca1840
Easy access is assured by its extremely low platform and the self-lowering ramps. The secure side rails give additional safety....
-
Accessible - Changes in Level
Changes in level greater than 1/2" shall be accomplished by means of a ramp. The maximum slope of a ramp in new construction shall be no greater than 1;12....
-
Attachment A: Violations Identified in the United States' Letter of Findings (Sept. 29, 2014)
[See subsections ...]
-
Figure 505.6 Horizontal Projections Below Gripping Surface – Drawing from the U.S. Access Board
-
Figure 505.4 Handrail Height – Drawing from the U.S. Access Board
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
11B-406.5.1 Location
Curb ramps and the flared sides of curb ramps shall be located so that they do not project into vehicular traffic lanes, parking spaces, or parking access aisles....
-
M303.3.3.1 Running Slope
Ramp runs shall have a running slope not steeper than 1:12....
-
5. Edge Protection
The MDE NPRM proposed edge protection on the ramps leading up to the raised platform (proposed M303.3.3.4), but did not require edge protection on the raised platforms themselves....
-
Q2: Milling a Road Surface
Q2: The Joint Technical Assistance states that “[r]esurfacing is an alteration that triggers the requirement to add curb ramps if it involves work on a street or roadway spanning from one...
-
1008.4 Play Components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with 1008.4....
-
1008.4 Play Components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with 1008.4....
-
11B-1008.4 Play components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with Section 11B-1008.4....
-
11B-1008.4 Play components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with Section 11B-1008.4....
-
11B-1008.4 Play components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with Section 11B-1008.4....
-
1008.4 Play Components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with 1008.4....
-
C. Air Travelers with a Disability Changing Planes
Where needed and to the extent required by law, you must provide services personnel, wheelchairs, and ramps or mechanical lifts....
-
M303.3.3.4 Edge Protection
Ramps with drop offs ½ inch (13 mm) or greater shall provide edge protection 2 inches (50 mm) high minimum on each side with a drop off....
