Detectable warnings shall be located so the edge nearest the curb is 6 inches (152 mm) minimum and 8 inches (203 mm) maximum from the demarcation line at the face of the curb between the...
Search Results "Assurances from Contractors"
Commonly Searched Documents
-
11B-705.1.2.2.1 Perpendicular curb ramps
-
11B-703.5.1 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
1.9.1.8 Adopting agency identification
To see the entire Chapter, consult California Code of Regulations, Title 24, Part 2 - 2022 California Building Code (2022 CBC), available for purchase from International Code Council (http...
-
11B-813.2.1.2 Clearance
End and side clearances shall be measured from the outermost extent of the table. Floor or ground surfaces of clearances shall comply with Section 11B-302....
-
11B-806.2.3.1 Personal lift device floor space
The clear space shall extend to points horizontally 30 inches (762 mm), vertically 7 inches (178 mm) and not more than 12 inches (305 mm) from the head and foot end of the bed....
-
11B-703.7.1 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
11B-703.6.2 Finish and contrast
Additional factors affecting the ease with which the text can be distinguished from its background include shadows cast by lighting sources, surface glare, and the uniformity of the text...
-
11B-1009.3 Sloped entries
Providing an aquatic wheelchair made of non-corrosive materials and designed for access into the water will protect the water from contamination and avoid damage to personal wheelchairs...
-
Technical Memorandum TM 2013-20 Valet Parking
October 3, 2010 2012 TAS Reference: 208 and 209.4 The 1994 TAS (and 1991 ADAAG) required valet parking facilities to provide a passenger loading zone but exempted the facilities from...
-
11B-404.2.4.2 Doorways without doors or gates, sliding doors, and folding doors
CLEARANCE Approach direction Perpendicular to doorway Parallel to doorway (beyond stop/latch side unless noted) From...
-
11B-604.2 Location
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
Step 4: Calculate Cumulative Deviation Percentage
The first point of deviation occurs 400 feet (122 meters) from the trailhead and the vista is only 250 feet (76 meters) from the trailhead....
-
General Accommodations
should have 1) an operating phone, cell-phone, TTY, and two-way radio so that emergency services can be contacted; 2) a closing door; 3) supplies that enable individuals to block smoke from...
-
§ 38.159(c)(5) Slope
If the height of the vehicle floor from which the ramp is deployed is 3 inches (75 mm) or less above a 6 inch (150 mm) curb, a maximum slope of 1:4 is permitted; if the height of the vehicle...
-
§ 38.29(b)
(b) Handrails and stanchions shall be provided in the entrance to the vehicle in a configuration which allows persons with disabilities to grasp such assists from outside the vehicle while...
-
11B-604.2 Location
The centerline of the water closet shall be 17 inches (432 mm) minimum to 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
11B-703.5.4 Character proportions
Characters shall be selected from fonts where the width of the uppercase letter “O” is 60 percent minimum and 110 percent maximum of the height of the uppercase letter “I”....
-
3.9 Oak Ridge Tinseltown 14, 755 W. Main Street, Oak Ridge, Tennessee
Main Street, Oak Ridge, Tennessee - In Auditorium 4, the four (4) wheelchair spaces shall be relocated one row farther back in the auditorium from their current location....
-
610.3.1 Rectangular Seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (380 mm) minimum and 16 inches (405 mm) maximum from the seat wall....
-
§382.51(b)(1)
(1) This means that passengers with a disability must be able to move readily through such terminal facilities to get to or from the gate and any other area from which passengers board the...
-
604.5.1 Side Wall
The side wall grab bar shall be 42 inches (1065 mm) long minimum, located 12 inches (305 mm) maximum from the rear wall and extending 54 inches (1370 mm) minimum from the rear wall. ...
-
M305.2.1 Location
Transfer supports shall comply with M305.2.1.1 or M305.2.1.2 and shall be located 1 ½ inches (38 mm) maximum measured horizontally from the plane defined by the nearest edge of the transfer...
-
Where Will the Person(s) Start Providing Assistance?
From the Location of the Person Requiring Assistance Does the person providing assistance need to go where the person who is blind or has low vision is located at the time the alarm sounds...
-
11B-608.3.3 Alternate roll-in type shower compartments
In alternate roll-in type shower compartments, grab bars shall be provided on the back wall and the side wall farthest from the compartment entry....