The ends of the support rail shall be 6 inches (152 mm) maximum from adjacent walls....
Search Results "End of Row Compartment"
-
11B-407.4.10.1 Location
-
11B-812.9 Surface marking
The centerline of the text shall be a maximum of 6 inches (152 mm) from the centerline of the vehicle space and its lower corner at, or lower side aligned with, the end of the vehicle space...
-
Standards: ADA Standard Section 2010
This of the ADA Standards covers the definition of the 2010 ADA Standards.
-
Standards: ADA Standard Section 1991
This of the ADA Standards covers the definition of the 1991 ADA Standards.
-
Standards: ADA Standard Section 2010
This of the ADA Standards covers the definition of the 2010 ADA Standards.
-
Benches [1011.2]
However, armrests on both ends of a bench could prevent a person using a mobility device from being able to transfer from the device onto the bench....
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
-
Fishing piers and platforms. (Section-by-Section Analysis)
If gangways (where only one end of route is attached to land) and floating piers (where neither end is attached to land) are involved, a number of exceptions are provided from the general...
-
M301.2.3 Transfer Sides
The configuration of stretchers will not allow for unobstructed access to a transfer surface located at either the foot end or head....
-
1. Sloped Surfaces
Rest one end of the level at the highest point of the sloped surface and lift the other end (see below) until the bubble is in the middle of the tube. This is the “level” position....
-
11B-104.1.1 Construction and manufacturing tolerances
All dimensions are subject to conventional industry tolerances except where the requirement is stated as a range with specific minimum and maximum end points....
-
Pilot Rock TQ700 Square Frame Square Utility Table
Model TQ700 Utility Tables are square tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
Pilot Rock T700 Square Frame Rectangular Utility Table
Model T700 Utility Tables are rectangular tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
§382.143(b)
or more passenger seats, you must provide training meeting the requirements of §382.141(a) for all personnel who deal with the traveling public in connection with flights that begin or end...
-
M304.2.2 Standing Supports
EXCEPTION: Diagnostic equipment with entry and exit permitting pass-through from one end to the other shall be permitted to provide one standing support on one side of the standing surface...
-
§27.1 Purpose.
The purpose of this part is to carry out the intent of section 504 of the Rehabilitation Act of 1973 (29 U.S.C. 794) as amended, to the end that no otherwise qualified individual with a...
-
§104.45(a) Housing provided by the recipient
At the end of the transition period provided for in subpart C, such housing shall be available in sufficient quantity and variety so that the scope of handicapped students' choice of living...
-
R305.2 Placement
Where the back of curb edge is tooled to provide a radius, the border dimension should be measured from the end of the radius....
-
§ 38.113(a)(2)
(2) Doorways at ends of cars connecting two adjacent cars, to the maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts...
-
§ 38.107(a)(3)
(3) A grab bar at least 24 inches long shall be mounted behind the water closet, and a horizontal grab bar at least 40 inches long shall be mounted on at least one side wall, with one end...
-
§ 38.123(a)(3)
(3) A grab bar at least 24 inches long shall be mounted behind the water closet, and a horizontal grab bar at least 40 inches long shall be mounted on at least one side wall, with one end...
-
Location of Controls
In transfer compartments, controls, faucets, and shower spray units were to be located no more than 15 inches on either side of the seat centerline, according to the proposed rule (608.5.1...
-
806.2.4 Toilet and Bathing Facilities
In addition, required roll-in shower compartments shall comply with 608.2.2 or 608.2.3....
-
806.2.4 Toilet and Bathing Facilities
In addition, required roll-in shower compartments shall comply with 608.2.2 or 608.2.3....
