Boarding platforms at transit stops must be positioned to coordinate with vehicles to minimize the vertical and horizontal gaps....
Search Results "Compliance Coordinator"
Commonly Searched Documents
-
Transit Stops (R308.1) (Section-by-Section Analysis)
- Accessibility Management Platform (AMP) Digital Accessibility Tool by SSB BART Group
-
Water Play Components: ADA Standard Section 1008.2.3
Where the surface of the accessible route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with 302, 403.3, 405.2, 405.3, and 1008.2.6...
-
11B-235.2.1 Dispersion
For example, a fuel pier may contain boat slips, and this type of short term slip would be included in determining compliance with Section 11B-235.2. ◼...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Existing parallel curb ramps with detectable warnings in compliance with the code requirements in effect at the time of installation shall not be required to provide a minimum 36 inches...
-
11B-404.3 Automatic and power-assisted doors and gates
An automatic door may be used as equivalent facilitation when it is technically infeasible to provide sufficient strike-side clearance for code compliance, but a power-assisted door may...
-
11B-233.3.4 Alterations
Exception: Where compliance with Sections 11B-809.2, 11B-809.3, or 11B-809.4 is technically infeasible, or where it is technically infeasible to provide an accessible route to a residential...
- Starodub, Inc. Ultra-Light Inertial Profiler (ULIP) for Sidewalks
-
3001.3 Accessibility
108.2.1.2 regulated by the Department of Housing and Community Development or Chapter 11B for applications listed in Section 1.9.1 regulated by the Division of the State Architect─Access Compliance...
-
§104.9 Administrative requirements for small recipients.
fifteen employees, or any class of such recipients, to comply with §§104.7 and 104.8, in whole or in part, when the Assistant Secretary finds a violation of this part or finds that such compliance...
-
Section 3. Fair Housing Act Design and Construction Requirements
A reprint of §100.205 was included to provide easy reference to (1) the Act's accessibility requirements, as codified by §100.205; and (2) the additional examples of methods of compliance...
-
§8.57(a) General
If there appears to be a failure or threatened failure to comply with this part and if the noncompliance or threatened noncompliance cannot be corrected by informal means, compliance with...
-
1002.4.7.1 Shoulder-to-Shoulder Seating
EXCEPTION: Where shoulder-to-shoulder companion seating is not operationally or structurally feasible, compliance with this requirement shall be required to the maximum extent practicable...
-
Doors
Recommendation: Compliance with 4.13.6 is recommended because while wider door openings may facilitate access, they do not fully compensate for latch-side clearance, particularly on the...
-
Can a more recent edition of the ASME A17.1 Safety Code for Elevators and Escalators (or the ASME A18.1 Safety Standard for Platform Lifts and Stairway Chairlifts) be used instead of the editions referenced in the Standards?
Compliance with a later edition may be possible under the provision for “equivalent facilitation” (§103) if it is comparable to, or stricter than, the referenced editions....
-
Cities and Counties: First Steps Toward Solving Common ADA Problems
First Steps Toward Solving Common ADA Problems Through its Project Civic Access initiative, the Department has worked with over 100 State and local governments to bring them into compliance...
-
9. Release of Claims
Released Claims Up to the Commencement of the Compliance Period Effective upon the entry of Judgment by the District Court, Plaintiffs and the Settlement Class members (and their respective...
-
Relationship to Other Laws
Compliance with the Department's ADA regulations does not ensure compliance with other Federal statutes....
-
IX. New Construction
Full compliance will be considered "structurally impracticable" only in those rare circumstances when the unique characteristics of terrain prevent the incorporation of accessibility features...
-
11B-1002.2 Accessible routes
In load or unload areas and on amusement rides, where compliance with Section 11B-405.2 _|Slope|_ is not structurally or operationally feasible, ramp slope shall be permitted to be 1:8 maximum...
-
11B-202 Existing buildings and facilities
INTERPRETATION Projects consisting solely of ADA barrier removal in response to court-ordered remediation might not necessarily result in compliance with CBC Chapter 11B....
-
Example 1: With Cooking Facilities
The following is a general analysis of the compliance requirements for these elements. Storage: Must comply with 804.5 and 811....
-
Technical Memorandum TM 2013-16 Residential Amenity Centers
Effective Date: June 1, 2013 2012 TAS Reference: 68.30(5) Areas, elements, and spaces in residential amenity centers used exclusively by residents* and their guests are not subject to compliance...