A landing at least 36” long at the top of curb ramps provides room to approach or exit ramps and turn without encountering compound slopes of flared sides....
Search Results "Running Slope"
2010 ADA Definition
Running Slope: The slope that is parallel to the direction of travel (see cross slope).
Filters
Commonly Searched Documents
-
Why is a top landing required at curb ramps if side flares are provided?
-
Passing Spaces [1016.4]
When passing spaces and resting intervals overlap, the technical requirements for resting intervals apply and the slope of the surface must be no steeper than 1:48 (2 percent) in any direction...
-
11B-406.5.3 Landings
The slope of the landing in all directions shall be 1:48 maximum. [2010 ADA Standards] 406.4 Landings. Landings shall be provided at the tops of curb ramps....
-
Speed Queen® Front Load Washer Information Video
manages and redistributes any and all out-of-balance loads to deliver uninterrupted cycles, virtually eliminate vibration and operate so quiet that neighboring residents won’t even know it’s running...
-
11B-1008.2.3 Water play components
route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302 _|Floor or Ground Surfaces|_, 11B-403.3, 11B-405.2 _|Slope...
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
Treads and Risers [4.9.2], Nosings [4.9.3]
Angled or rounded nosings or sloped risers help prevent this hazard and provide a smoother transition. Straight risers without nosings are acceptable....
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
11B-1008.2.3 Water play components
route, clear floor or ground spaces, or turning spaces serving water play components is submerged, compliance with Sections 11B-302 _|Floor or Ground Surfaces|_, 11B-403.3, 11B-405.2 _|Slope...
-
11B-504.5 Nosings
Risers shall be permitted to slope under the tread at an angle of 30 degrees maximum from vertical....
-
Willoughby Industries ASHS-1013-06-15-HC Ligature-Resistant 15" wide Lavatory
.), sloped backsplash, and self-draining soap dish. Anchoring shall be by standard 4-point system: threaded rods, nuts and washers shall be furnished for walls up to 8" thick....
-
Sargent 8200 Mortise Lock with BHL Trim
Sloping surfaces and overlapping rose and lever address safety concerns common in behavioral health facilities....
-
Accessible Miniature Golf Course Holes
least fifty percent (50%) of golf holes on miniature golf courses to be accessible, including providing a clear floor or ground space that is 48 inches minimum by 60 inches minimum with slopes...
-
1.15 Stadium-style seating, stadium section, or stadium seating
Each row of stadium seating is elevated above the row immediately ahead of it and is accessed by stepped, rather than sloped, aisles....
-
K. Eating Areas
Eating Areas An accessible route, at least 36 inches wide and without steps or steep slopes, must be provided to and throughout the food service and eating areas of the shelter....
-
7.4.9 Trail Facilities
When the surface of the required clear ground space for trail facilities is not paved or is not elevated above the natural ground, slopes not steeper than 1:20 (5 percent) shall be permitted...
-
4.2.1 General
In alterations, where a condition for exception in section 1.1 prohibits full compliance with a specific requirement for clear floor or ground space surface, slope, size, or location, the...
-
1132A.4, Item 4
., concrete, brick, flagstone) may have a maximum change in height from the interior landing of 1 inch (25.4 mm), provided a ramp with a maximum slope of 1:8 is permanently installed....
-
§ 38.83(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
-
§ 38.125(c)(3) Ramp threshold
Changes in level between 1/4 inch and 1/2 inch shall be beveled with a slope no greater than 1:2....
-
Salsbury Industries Designer Wood Locker Single Tier 1 Wide
feet high single tier designer lockers 13-3/4" D for 15" deep designer lockers 16-3/4" D for 18" deep designer lockers 19-3/4" D for 21" deep designer lockers Options Sloping...
-
Salsbury Industries Designer Wood Locker Single Tier 3 Wide
feet high single tier designer lockers 13-3/4" D for 15" deep designer lockers 16-3/4" D for 18" deep designer lockers 19-3/4" D for 21" deep designer lockers Options Sloping...
-
R305.1.4 Size
At curb ramps and blended transitions, detectable warning surfaces shall extend the full width of the ramp run (excluding any flared sides), blended transition, or turning space....
-
Clear Width [§405.5]
Clear Width [§405.5] Ramp runs must have a clear width of 36” minimum (measured between handrails where provided)....
