A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
Search Results "Running Slope"
-
11B-1010.1 Turning space
-
1010.1 Turning Space
A circular turning space 60 inches (1525 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
Load and Unload Areas
Load and Unload Areas The floor or ground surface in the load and unload areas must have a slope not steeper than 1:48 and be stable, firm, and slip resistant....
-
11B-1010.1 Turning space
A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
11B-1010.1 Turning space
A circular turning space 60 inches (1524 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
11B-809.8.1 Door Thresholds
Secondary exterior door thresholds, including sliding door tracks, shall be 3/4 inch (19.1 mm) high maximum with a 1:2 maximum slope....
-
1010.1 Turning Space
A circular turning space 60 inches (1525 mm) diameter minimum with slopes not steeper than 1:48 shall be provided at shooting facilities with firing positions....
-
21.1 Q. Is a dwelling unit that has a split entry foyer...required to be accessible if it is a ground floor unit in a covered multifamily dwelling?
This would preclude a split level foyer, unless a properly sloped ramp can be provided....
-
305.2 Floor or Ground Surfaces
EXCEPTION: Slopes not steeper than 1:48 shall be permitted....
-
1011.2 Clear Ground Space
This section requires a clear ground space to be provided at outdoor constructed features and includes specific provisions for the size and location (1011.2.1), surface (1011.2.2), slope...
-
1017.8 Resting Intervals
This section contains the technical requirements for the length (1017.8.1), width (1017.8.2), and slope (1017.8.3) of resting intervals; and for a turning space (1017.8.4) where resting...
-
Wet Conditions [§405.10]
Landings are permitted slopes not steeper than 1:48 to allow for drainage....
- Whitehall Mfg. Ligature Resistant Solid Surface Basin
- Whitehall Mfg. Ligature-Resistant Box with Hydraulic Flush Valve for Top Supply ADA Toilet
- American Standard Ovalyn™ Universal Access Undercounter Sink
- Magnuson Group UMEA Waste Receptacles
- Delta Single Handle Pull-Down Bar/Prep Faucet with Touch2O Technology 9959T-DST
- Delta Single Handle Lavatory with Touch2O.xt 561T-DST
-
19.1 Q. If a sliding door track has a threshold of 3/4, does this trigger requirements for ramps?
The Guidelines at Requirement 4 provide that thresholds at doors, including sliding door tracks, may be no higher than 3/4 and must be beveled with a slope no greater than 1:2....
-
3a.
If yes, is a ramp or sloped hallway provided? Yes _____ No _____ If yes, go to question E1-4. Note: A ramp, lift, or elevator can be used to provide access to floor levels....
-
Data Collection Procedures
Potential causes for variation might be running and cross slope, a difference in drainage and/or adjacent runoff, and sun vs. shade location of reading locations....
-
Installation
Sites installed with EWF were found to have the highest SDS within the first year of installation including deficiencies with excessive running slope, cross slope and change in level. ...
-
Attachment I
All spaces and access aisles for persons with disabilities shall be flat and level, with slopes and cross-slopes not exceeding 1:50 in all directions, and their surfaces shall be firm, stable...
-
Front Entry
Water fountain for the relaxing sound of running water to reduce stress Video intercom which shows images of the visitor throughout the house and records visitor while we are...