A 36 inch (914 mm) wide minimum entry shall be provided at one end of the long side of the compartment....
Search Results "Head End Wall"
Filters
Commonly Searched Documents
-
11B-608.2.3 Alternate roll-in type shower compartments
-
M305.3.1.2 Diagnostic Equipment Containing a Wheelchair Space
On diagnostic equipment containing a wheelchair space and permitting pass-through from one end to the other, the length of the gripping surface on horizontal standing supports shall be at...
-
T505.3 Location of Operable Parts
Operable parts shall be located adjacent to the toe end of the clear space or shall be located no more than 10 inches (255 mm) measured from the centerline of the long dimension of the clear...
-
Running Slope
In other words, the slope is the difference in elevation from the beginning to the end of a part of a trail, outdoor recreation access route, or beach access route, measured in the direction...
-
Title and label placement
However, it was at the bottom of the map and most people either missed it or didn’t find it until the end of their exploration....
-
I. BACKGROUND
at the northern end....
-
Rear Grab Bar
The proposed rule specified that the rear grab bar be 24 inches long minimum, centered on the water closet, or at least 36 inches long "where wall space permits" (604.5.2)....
-
11B-903.4 Back support
The bench shall provide for back support or shall be affixed to a wall along its long dimension....
-
1136A.1 Receptacle heights
Physical barriers and obstructions shall not extend more than 25 inches (635 mm) from the wall beneath the receptacle....
-
Pilot Rock TQ700 Square Frame Square Utility Table
Model TQ700 Utility Tables are square tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
Pilot Rock T700 Square Frame Rectangular Utility Table
Model T700 Utility Tables are rectangular tables designed with clean-cut square end frames and inlaid table planks. No benches are included with this utility table. ...
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
704.6 Structural stability
The wall shall extend to the height required by Section 704.11 and shall have sufficient structural stability such that it will remain in place for the duration of time indicated by the...
-
609.5 Surface Hazards
Grab bars and any wall or other surfaces adjacent to grab bars shall be free of sharp or abrasive elements and shall have rounded edges....
-
4.34.6.4(2)
The finished floor shall extend under the counter to the wall....
-
Non-Circular Cross Section and Clearance (§505.5, §505.7)
Keep wall surfaces above handrails free of any protrusions....
-
11B-602.8 Depth
Wall- and post-mounted cantilevered drinking fountains shall be 18 inches (457 mm) minimum and 19 inches (483 mm) maximum in depth....
-
11B-608.10 Soap dish
Where a soap dish is provided, it shall be located on the control wall at 40 inches (1016 mm) maximum above the shower floor, and within the reach limits from the seat....
-
Common Problems with Signs
Common Problems with Signs Ø Some signs – such as permanent room signs – are required to have Braille, high contrast, and raised lettering and must be located on the wall to the...
-
General [9.1.1]
Wall-mounted objects, such as light fixtures, must be selected and mounted so they do not pose a hazard to people with vision impairments....
-
11B-604.3.2 Overlap
Exception: In residential dwelling units, a lavatory complying with Section 11B-606 shall be permitted on the rear wall 26 inches (660 mm) minimum from the water closet centerline to allow...
-
11B-805.7 Built-in cabinets and work surfaces
California, issued Code Application Notice CAN 2-11B, dated 9/9/14, which includes the following interpretation of Section 11B-805.7: Built-in equipment consoles include recessed or wall...
-
§ 36.304(d)(4)(ii)
(ii) Where an existing swimming pool has less than 300 linear feet of swimming pool wall, it shall be exempt from the provisions of section 242.2 of the proposed standards; and...
