EXCEPTION: Where the clear width at the turn is 60 inches (1525 mm) minimum compliance with 403.5.2 shall not be required. Figure 403.5.2 Clear Width at Turn...
Search Results "Compliance"
Filters
Commonly Searched Documents
-
403.5.2 Clear Width at Turn
-
Exceptions [1014.1, Exceptions 1 and 2]
When a condition for exception does not permit full compliance with a specific provision in the technical requirements for camp shelters, the camp shelter must comply with the specific provision...
-
12185(e) Review
the study required by subsection (a) of this section, the Office of Technology Assessment shall provide a preliminary draft of such study to the Architectural and Transportation Barriers Compliance...
-
412.1 General (Section-by-Section Analysis)
Would compliance with section 412 be readily achievable for manufacturers of mobile telecommunications equipment?...
-
106.5.68 Technically Infeasible
essential part of the structural frame; or because other existing physical or site constraints prohibit modification or addition of elements, spaces, or features that are in full and strict compliance...
-
4.1.7(1)(a) General Rule
applicable technical specifications of 4.2 through 4.35 and the applicable special application sections 5 through 10 unless it is determined in accordance with the procedures in 4.1.7(2) that compliance...
-
10.2.1(3)
Signs that are sized to the maximum dimensions permitted under legitimate local, state or federal regulations or ordinances shall be considered in compliance with 4.30.2 and 4.30.3 for purposes...
-
4.1.7(2)(a)(ii) ADA Application
If the State Historic Preservation Officer or Advisory Council on Historic Preservation agrees that compliance with the requirements for accessible routes (exterior and interior), ramps,...
-
LARGE AREA ASSISTIVE LISTENING SYSTEMS (ALS): REVIEW AND RECOMMENDATIONS
Large Area Assistive Listening Systems: Review and Recommendations Final Report to United States Architectural and Transportation Barriers Compliance Board (U.S....
-
3.4.1 General
When a new viewing area is constructed, or an existing viewing area is altered or reconstructed, if a condition for exception in section 1.1 prohibits full compliance with a specific requirement...
-
§100.75(d)
(d) 24 CFR part 109 provides information to assist persons to advertise dwellings in a nondiscriminatory manner and describes the matters the Department will review in evaluating compliance...
-
III-9.4000 Preliminary determination
If the Assistant Attorney General's office decides to proceed, the office will consult with the Architectural and Transportation Barriers Compliance Board....
-
2.3.1
2.3.1 Define the measurement protocols to be used to check for compliance with the tolerances and standards....
-
6.2 Additional Accessible Elements
Typically, Item 6 will come into play only when all of the elements in the preceding items either 1) are in compliance with the requirements, 2) have been included in the project’s path...
-
Small entities potentially affected by proposed standards
discussed below, if an enforcing authority such as DOJ adopts the standards as mandatory requirements for entities subject to its jurisdiction, small health care providers may experience some compliance...
-
§ 37.5(i)(1) Private entity-private transport
This obligation includes, with respect to the provision of transportation services, compliance with the requirements of the rules of the Department of Justice concerning eligibility criteria...
-
List of Subjects in 36 CFR Part 1194
., Chair, Architectural and Transportation Barriers Compliance Board For the reasons set forth in the preamble, the Board adds part 1194 to Chapter XI of title 36 of the Code of Federal...
-
11B-403.5.2 Clear width at turn
Exception: Where the clear width at the turn is 60 inches (1524 mm) minimum compliance with Section 11B-403.5.2 shall not be required....
-
§ 37.5(i)(1) Private entity-private transport
This obligation includes, with respect to the provision of transportation services, compliance with the requirements of the rules of the Department of Justice concerning eligibility criteria...
-
419.7 Accessibility
ETA Editor's Note California Building Code Chapters 5 through 8 are not adopted by the Division of the State Architect - Access Compliance (DSA-AC), and have been omitted....
-
11B-403.5.2 Clear width at turn
Exception: Where the clear width at the turn is 60 inches (1524 mm) minimum compliance with Section 11B-403.5.2 shall not be required....
-
419.7 Accessibility
ETA Editor's Note California Building Code Chapters 5 through 8 are not adopted by the Division of the State Architect - Access Compliance (DSA-AC), and have been omitted....
-
1133A.7 Knee and toe space
space, when required by Section 1133A, shall comply with Section 1138A.2 and the following: The knee and toe space shall be clear and unobstructed, or removable base cabinets in compliance...
-
11B-202.5 Alterations to qualified historic buildings and facilities
EXCEPTION: Where the State Historic Preservation Officer or Advisory Council on Historic Preservation determines that compliance with the requirements for accessible routes, entrances, or...