The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
403.3 Slope
-
§ 38.83(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
Conclusions
All the surfaces pass the existing specifications for impact attenuation of playground surfaces. 2....
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
Tread Obstacles [1017.5]
A tread obstacle is anything that interrupts the evenness of the tread surface....
-
T402.7 Edge Guards
Ramps and bridgeplates shall provide edge guards continuously along each side of the ramp or bridgeplate to within 3 inches (75 mm) of the end of the ramp or bridgeplate that is deployed...
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
11B-403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
11B-405.7.4 Change in direction
Ramps that change direction between runs at landings shall have a clear landing 60 inches (1525 mm) minimum by 72 inches (1829 mm) minimum in the direction of downward travel from the upper...
-
A4.8.1 General
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 Location at Marked Crossings
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). ...
-
A4.8.1 GENERAL
Ramps are essential for wheelchair users if elevators or lifts are not available to connect different levels....
-
4.7.9 LOCATION AT MARKED CROSSINGS
Curb ramps at marked crossings shall be wholly contained within the markings, excluding any flared sides (see Fig. 15). Figure 15 Curb Ramps at Marked Crossings...
-
A4.8.4 Landings
A ramp landing that is not level causes individuals using wheelchairs to tip backward or bottom out when the ramp is approached....
-
Atlantis Railing
full sets of ADA compliant accessibility railings for ramps and stairs....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
1011.5.2 Cooking Surfaces
Where provided, cooking surfaces shall be 15 inches (380 mm) minimum and 34 inches (865 mm) maximum above the ground....
-
Location at Marked Crossings [4.7.9]
The foot of a curb ramp must be contained within the crosswalk, where one is marked....
-
R409.1 General
Handrails required at ramps and stairways, and handrails provided on pedestrian circulation paths shall comply with R409. Advisory R409.1 General....
-
WoodCarpet Ground Surface System: WoodCarpet Mat Installation Video
-
406.8 Detectable Warnings
A curb ramp shall have a detectable warning complying with 705....
-
3.2.4 Slope
The ground surface in all camp living areas shall have a slope of no more than 1:48 (2 percent) in any direction. Exception....
-
NanoPave® 2-in-1 Joint Stabilizer and Sealer
NP-JSS is a UV resistant, VOC-free sealant that protects and helps maintain the natural beauty of most paving surfaces....
