Slip resistant & serrated surfaces also available....
Search Results "Ramp Surface"
Filters
Commonly Searched Documents
-
Aluminum Dove Tail Series Pressure-Locked Grating
-
§ 38.159(c)(3) Ramp threshold
(3) Ramp threshold. The transition from roadway or sidewalk and the transition from vehicle floor to the ramp may be vertical without edge treatment up to 1/4 inch (6.5 mm)....
-
Top Landings
Commenters advised that landings should be specified at the top of curb ramps. Response....
-
11B-226.1 General
Where dining surfaces are provided for the consumption of food or drink, at least 5 percent of the seating spaces and standing spaces at the dining surfaces shall comply with Section 11B...
-
Wheelchair accessible seating is required. At least one percent of the seating must be wheelchair seating locations.
Each wheelchair seating location is an open, level space that accommodates one person using a wheelchair and has a smooth, stable, and slip-resistant surface....
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
The ADA Standards require that curb ramps include features called “detectable warnings.”...
-
302.3 Openings
Openings in floor or ground surfaces shall not allow passage of a sphere more than 1/2 inch (13 mm) diameter except as allowed in 407.4.3, 409.4.3, 410.4, 810.5.3 and 810.10....
-
Rotational Penetrometer
A wheelchair caster placed on a spring loaded caliber in a metal tripod frame which suspends the caster about 6 inches over the surface. ...
-
General (R304.1) (Section-by-Section Analysis)
General (R304.1) (Section-by-Section Analysis) Curb ramps are ramps that are cut through or built up to the curb (see R105.5)....
-
d-vi
Does the ramp have a level landing that is at least 60 inches long at the top and bottom of each ramp section or where the ramp changes direction?...
-
Height: ADA Standard Section 902.4.2
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (760 mm) maximum above the finish floor or ground.
-
4.19.4 EXPOSED PIPES AND SURFACES
There shall be no sharp or abrasive surfaces under lavatories....
-
Findings
The following are the predominant findings from this study: No single type of surface material/system was found to be the most accessible surface or better than others when comparing...
-
4.19.4 Exposed Pipes and Surfaces
There shall be no sharp or abrasive surfaces under lavatories....
-
Dimensions for Adults and Children: ADA Standard Section 102
Section 102 of the ADA Standards covers information on the dimensions for adults and children.
-
11B-102 Dimensions for adults and children
this chapter includes technical requirements based on children’s dimensions and anthropometrics for drinking fountains, water closets, toilet compartments, lavatories and sinks, dining surfaces...
-
11B-405.7.4 Change in direction
ramp run. ...
-
Tile Tech Pavers® Stamp-Tech™ Series Pavers
Its irregular top surface was developed from actual sections of stone. By rotating the direction of the pavers during installation the natural effect is complete....
-
Unity Surfacing Systems Soft-Land Rubberized Safety Surfacing
Soft-Land is "Unity's" 3", 3 1/4", 3 1/2" and 3 3/4" thick rubberized safety surfacing, flooring and paver products that are made from 100% recycled tires and rubber granules....
-
1014.2.1.1.1 Surface
The surface of the clear ground space shall be firm and stable....
-
1014.2.1.1.1 Surface
The surface of the clear ground space shall be firm and stable....
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
403.3 Slope
The running slope of walking surfaces shall not be steeper than 1:20. The cross slope of walking surfaces shall not be steeper than 1:48....
-
§ 38.83(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
