Because a mix of public and private facilities are used as polling places, public entities may ensure Election Day accessibility of a polling place by using low-cost temporary measures,...
Search Results "Measuring Technique"
Commonly Searched Documents
-
POLLING PLACE ACCESSIBILITY IS REQUIRED BY THE AMERICANS WITH DISABILITIES ACT
- Just Manufacturing Deck Mounted Classroom Faucet with Vandal Resistant Lever Handle
- AJW Architectural Products U109 16 oz. Plastic Bulb Liquid Soap Dispenser - Surface Mounted
- Just Manufacturing Classroom Concealed Ledgemount Single Handle Restricted Swing Faucet
- Better Living LINEA Luxury Soap Dispenser
- Precision Safe Sidewalks LLC Sidewalk Trip Hazard Repair Service
- M-D Building Products, Inc. GEN2 SmartToolâ„¢ Digital Level
- Corada Product Certification Process
-
Accessible Product Certification Process
Manufacturers are given a time frame in which to implement corrective measures....
-
11B-706.1 General
Sound pressure levels (SPL), expressed in decibels, measure output sound volume....
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
Companion Seats
Consistent with the ANSI A117.1‒2003 standard, the provision in the final rule specifies that shoulder alignment is to be measured 36 inches from the front of the wheelchair space and that...
-
Building Entrance
(See Part 2 of this document for tips on taking measurements.)...
-
M301.2.1 Adjustability (Section-by-Section Analysis)
; (3) at least four additional transfer heights located between the low and high transfer heights, separated by one inch minimum increments; and (4) the transfer surface height will be measured...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
604.3.2 Overlap
complying with 606 shall be permitted on the rear wall 18 inches (455 mm) minimum from the water closet centerline where the clearance at the water closet is 66 inches (1675 mm) minimum measured...
-
703.2.7 Character Spacing
Character spacing shall be measured between the two closest points of adjacent raised characters within a message, excluding word spaces....
-
505.4 Height
A maximum height of 28 inches (710 mm) measured to the top of the gripping surface from the ramp surface or stair nosing is recommended for handrails designed for children....
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
R302.5 Grade
The grade of the pedestrian access route is measured parallel to the direction of pedestrian travel....
-
11B-505.10.3 Bottom extension at stairs
The horizontal extension of a handrail shall be 12 inches (305 mm) long minimum and a height equal to that of the sloping portion of the handrail as measured above the stair nosings....
-
Space Allowance and Reach Ranges [4.2]
Adult dimensions and measures for standard manual wheelchairs form the basis of many ADAAG specifications....
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...