Hall signals shall comply with 407.2.2....
Search Results "Signal-to-Noise Ratio"
-
408.2.2 Hall Signals
-
Door and Signal Timing for Hall Calls [4.10.7], Door Delay for Car Calls [4.10.8]
Timing, based on the distance between the farthest call button and the elevator door, begins with visible and audible signaling of car arrival....
-
4.10.4(1)
(1) Hall lantern fixtures shall be mounted so that their centerline is at least 72 in (1830 mm) above the lobby floor. (See Fig. 20.)
-
Issue 12: Audible beaconing
Issue 12: Audible beaconing Audible beaconing -- providing a louder audible WALK signal in order to provide directional guidance to pedestrians who are blind -- is not needed at all intersections...
-
11B-408.2.2 Hall signals
Hall signals shall comply with Section 11B-407.2.2....
-
11B-408.2.2 Hall signals
Hall signals shall comply with Section 11B-407.2.2....
-
11B-408.2.2 Hall signals
Hall signals shall comply with Section 11B-407.2.2....
-
A4.10.7 Door and Signal Timing for Hall Calls
This paragraph allows variation in the location of call buttons, advance time for warning signals, and the door-holding period used to meet the time requirement....
-
A4.10.7 DOOR AND SIGNAL TIMING FOR HALL CALLS
This paragraph allows variation in the location of call buttons, advance time for warning signals, and the door-holding period used to meet the time requirement....
-
Audible WALK indications
When the pedestrian pushbutton is properly located close to the departure curb, a low-volume WALK signal will be adequate for usability....
-
302.5 With Limited Hearing
Where an audible mode of operation is provided, ICT shall provide at least one mode of operation that enables users to make use of limited hearing.
-
Vibrotactile WALK indications
The vibrotactile indication is particularly useful for pedestrians who have both hearing and visual impairments and also allows pedestrians to tactually confirm audible signal information...
-
R209.1 General
Where pedestrian signals are provided at pedestrian street crossings, they shall include accessible pedestrian signals and pedestrian pushbuttons complying with sections 4E.08 through 4E...
-
Issue 15: Installation Errors Increase Risk
When the WALK signal begins, you hear a fast ticking sound”....
-
4.10.7* Door and Signal Timing for Hall Calls
For cars with in-car lanterns, T begins when the lantern is visible from the vicinity of hall call buttons and an audible signal is sounded....
-
4.10.7* DOOR AND SIGNAL TIMING FOR HALL CALLS
For cars with in-car lanterns, T begins when the lantern is visible from the vicinity of hall call buttons and an audible signal is sounded....
- Otis Elevator Advanced Lantern Retrofit
-
Issue 14: Inspection of contractor’s work - Beware of field changes!
Figure 22: When two APS are mounted on an existing signal pole, one is poorly located....
- ThyssenKrupp Elevator Signa 4 Signal Fixtures
-
1132A.10 Door signal devices
1132A.10 Door signal devices. Every primary entrance to a covered multifamily dwelling unit shall be provided with a door buzzer, bell, chime or equivalent....
-
Issue 4: Wrong pole! …Wrong message!
However, APS can be wired to a control board in the pedestrian signal head or through the controller, so it may be necessary to move the pedestrian signal head (or to completely rewire each...
-
Issue 7: Repair/replacement (put it back right!)
Issue 7: Repair/replacement (put it back right!) An APS that was knocked down in a crash was reinstalled by workers who did not know how the device was supposed to function. After...
-
Pushbutton locator tone
Pushbutton locator tone The pushbutton locator tone is a low-volume tick or tone that repeats constantly, at one-second intervals, during the flashing and steady DON’T WALK...
-
Issue 11: Good vibrations (vibrotactile indications)
The vibrotactile indication provides WALK signal information for pedestrians who are both visually and hearing impaired and also may be used by pedestrians who are visually impaired (with...