Where towel or sanitary napkin dispensers, waste receptacles, or other accessories are provided in toilet facilities, at least one of each type shall be located on an accessible route....
Search Results "Recessed Seat Cover Dispenser"
Filters
Commonly Searched Documents
-
11B-603.5 Accessories
-
11B-607.3 Seat
A permanent seat at the head end of the bathtub or a removable in-tub seat shall be provided. Seats shall comply with Section 11B-610....
-
11B-610.2 Bathtub seats
The top of bathtub seats shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the bathroom finish floor....
-
Recessed Doors and Gates [§404.2.4.3]
Recessed Doors and Gates [§404.2.4.3] Thick walls, casework, shelving, columns and other elements can cause doors or gates to be recessed....
-
12114(c) Authority of Covered Entity
(c) Authority of Covered Entity.-- A covered entity --...
-
12114(c) Authority of covered entity
(c) Authority of covered entity A covered entity...
-
Feminine product dispensers
Feminine product dispensers: b....
-
11B-604.7 Dispensers and disposal units
Toilet paper dispensers and sanitary napkin disposal units shall comply with Section 11B-604.7....
-
Rectangular Seats: ADA Standard Section 610.3.1
Section 610.3.1 covers the current ADA Standards for rectangular shower compartment seats.
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
Rear Grab Bar
Saving space by locating a lavatory closer to the water closet on the same plumbing wall could only be accomplished by recessing the lavatory so that it does not overlap the clear floor...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
-
12111(2) Covered entity
(2) Covered entity The term "covered entity" means an employer, employment agency, labor organization, or joint labor-management committee....
-
604.7 Dispensers
604.7 Dispensers....
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
604.7 Dispensers
Toilet paper dispensers shall comply with 309.4 and shall be 7 inches (180 mm) minimum and 9 inches (230 mm) maximum in front of the water closet measured to the centerline of the dispenser...
-
AJW Architectural Products U841 Dual Hooded Toilet Tissue Dispenser w/Auto Reserve - Recessed - Non-Controlled
Concealed inner dispensing mechanism is #18 ga stainless steel. Back: Fabricated of #18 ga stainless steel with multiple welds to cabinet body forming a one piece construction....
-
11B-228 Depositories, vending machines, change machines, mail boxes, fuel dispensers, and electric vehicle charging stations.
[2010 ADA Standards] 228 Depositories, Vending Machines, Change Machines, Mail Boxes, and Fuel Dispensers...
-
L-Shaped Seats: ADA Standard Section 610.3.2
Section 610.3.2 covers the current ADA Standards for L-shaped shower compartment seats.
-
Terms “employer” and “employer or other covered entity”
Finally, the terms “employer” and “employer or other covered entity” are used interchangeably throughout this appendix to refer to all covered entities subject to the employment provisions...
-
F228 Depositories, Vending Machines, Change Machines, and Mail Boxes
Exceptions to these requirements are provided for fuel dispensers....
-
Seats: ADA Standard Section 610
Section 610 covers the current ADA Standards for seats in bathtubs and shower compartments.
-
11B-610.3.2 L-shaped seats
The rear edge of an L-shaped seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall....
